Hello I have a 2002 Corolla and i recently purchased an Omega K9classic-e car alarm. I still haven't installed it but i tested it and everything is working properly. i'm sure i don't have relays built in the brain for the doors and this is what i'm asking for. i purchased 4 actuator and i just need the relay wiring diagram that connects the brain to the actuators. I found a couple diagrams but they were for all doors, no priority. I also found a similar
topic on this forum, but it was closed and i couldn't post my additional question. It gives there directions with an AUX output, but I'm sure that the alarm supports single pulse for driver door priority unlock and then the second pulse for the other doors I would greatly appreciate if someone has a wiring diagram for a driver door lock priority with just the four pin output from the brain. Thanks,
Svilen
P. S. brain has currently 2 wires output (blue and green and there are 2 more pins for priority but not wired) and each actuator has 2 wires (blue and green again). I can figure out the polarity since it switches in order to do lock/unlock so that's not that important
You will need three relays. First one for the lock output...30 out to all lock wires for the acutators (probably green depending on how you install them) 87a to ground, 86 & 87 to 12V, 85 to lock output from alarm.
Second one will be for the Driver's unlock: Pin 30 to driver's door actuator unlock, pin 87a to ground, 86 & 87 to 12V, 85 to unlock output from alarm.
Third will be to all other doors: Pin 30 to all other actuator unlock wires, pin 87a to ground, 86 & 87 to 12V, 85 to secondary unlock from alarm.