05 Ion remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=78852
Printed Date: June 10, 2024 at 8:54 AM

Topic: 05 Ion remote start

Posted By: dea,can
Subject: 05 Ion remote start
Date Posted: June 07, 2006 at 9:04 PM

hi there this one is giving trouble the alarm part works good all doors trigger,E brake gets power plxr bypass works just cant seem to get into ready mode u lights flash 4 times when turn off the key car stalls ,and the clutch switch its powered from the R/S starter wire of unit.? any info will help at this time thanks.

-------------
dragon

Replies:

Posted By: KarTuneMan
Date Posted: June 07, 2006 at 10:53 PM

What did you install? Brand, model # etc...

-------------

Posted By: dea,can
Date Posted: June 07, 2006 at 11:19 PM

autostart 6265 sh used this model before must be something with the ions i guess.or me posted_image

-------------
dragon

Posted By: Velocity Motors
Date Posted: June 08, 2006 at 8:26 AM

Check that your not getting ground on the hood pin switch or 12 volts on the brake wire. Some vehicles have the dome light turn on as you close the last door which cancels ready mode. This has been a problem on some Ford's and some Chevy's that I've worked on which were manual vehicles.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: jtmack1
Date Posted: June 08, 2006 at 9:28 AM

If you get your door triggers right at each pin switch and diode isolate them it will work. The only problem is that the radio will stay on. It will turn off in 10 min or so. I havent yet found a better way than this to do it.

Posted By: dea,can
Date Posted: June 10, 2006 at 5:18 PM

2 things that i have found out is u cant use the wire in the drivers kick for Ebrake u have go right to the switch

to put it into readymode.

for the radio u have to pulse this wire connect your remote starter's start wire directly to this wire @the pcm at pin 54 for automatics for manuals vehicles pin 70@ pcm pcm located under hood left side of the engine.to turn off the radio.

-------------
dragon

Posted By: gus1
Date Posted: June 12, 2006 at 5:34 PM

Or, you could just pulse your driver's door pin with a rearm pulse, diode isolating away from the starter appropriately........ same way we have been doing it on GM's for years.....

Gus

-------------
Wherever I go, that is where I end up......