compustar remote issues
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=79034
Printed Date: May 19, 2025 at 8:11 AM
Topic: compustar remote issues
Posted By: 1herm4matrix
Subject: compustar remote issues
Date Posted: June 12, 2006 at 6:39 PM
i just installed a 2wssr system in my 2003 toyota matrix but i cant get the remote to program. i have done a search on this site and there is tons of information on this. i have tried just about everything to try to get this thing to work. i purchased two of these systems so have swaped out the brain and tried a second remote,still no luck so i'm assuming the trouble has something to do with my wiring. the only wire that i think might be causing my problem is the cn1 pin 7 GREEN/ red wire. in the manual it says that this wire will "monitor the status of the vehicle and for programming". were should this wire be connected?? i connected at the ignition harness to the wire providing 12v when the key is "on".
Replies:
Posted By: Velocity Motors
Date Posted: June 12, 2006 at 7:56 PM
If you connected the GREEN wire to the BLACK/ white at the ignition then the other probable cause will be to relocate your ground wire to the system. Also, you must toggle the ignition 5 times within 3 seconds.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: 1herm4matrix
Date Posted: June 12, 2006 at 8:02 PM
so this green wire should be connected to the BLACK/ white at the ignition harness?? iwill try this...
|