Print Page | Close Window

2001 Vw Golf alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=79084
Printed Date: May 02, 2024 at 7:36 AM


Topic: 2001 Vw Golf alarm

Posted By: IIrjII
Subject: 2001 Vw Golf alarm
Date Posted: June 13, 2006 at 4:11 PM

I have a question about this 01 Golf that i did.  I installed a Viper 791xv into a couple of weeks ago.  Lately the alarm has been going off for no reason.  When I look at the remote, it says that  a door trigger was set off.  But the doors are closed all the way.  Can anyone tell me why the alarm is doing this?  thanks



Replies:

Posted By: sigh
Date Posted: June 14, 2006 at 8:27 AM
i would say it might be a connection when you wired it. You might have not done it good, and due to vibrations and stuff it just unsoldered and therefore it is disconnecting from time to time, or you might have just not isolated them good and they my be grounding somewhere, and if your door trigger is '-', the alarm sets off.

I would say check all your connections when you wired the remote, and actually just check your door trigger connections




Posted By: joe_1
Date Posted: June 14, 2006 at 12:58 PM
what wire did you tap into seperate door trigger wire, or the dome light wire on the factory alarm?

-------------
i am also a technician so if you have any engine trouble let me know, and i will do my best to help.




Posted By: gus1
Date Posted: June 14, 2006 at 1:15 PM
Using the domelight is not a good idea on these cars. Contrary to popular belief, there is only one trigger available at the CCM that works properly, and that is the driver's door only.

Pull a separate door trigger into each door.... it is BROWN / white in each door. Diode isolate accordingly. Not too bad..... maybe a half hout total.

Gus


-------------
Wherever I go, that is where I end up......




Posted By: joe_1
Date Posted: June 14, 2006 at 1:55 PM

hi gus my bro has a mk4 golf, i put a clifford on it couple weeks ago, i used the domelight and both the oem, and clifford have any probs everything operates as it should.

also if you do decide to use the seperate door wires as gus has described do use diodes as the display on the dash will tell you wrong info as it what door is open etc.



-------------
i am also a technician so if you have any engine trouble let me know, and i will do my best to help.





Print Page | Close Window