Where is the hole on firewall of Tiburon?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=79598
Printed Date: May 15, 2025 at 5:37 AM

Topic: Where is the hole on firewall of Tiburon?

Posted By: equate
Subject: Where is the hole on firewall of Tiburon?
Date Posted: June 25, 2006 at 11:24 AM

I am installing the alarm on TIBURON 2003. I wont drill a hole on firewall. Any body knows Where is the hole on firwall?

Replies:

Posted By: Ravendarat
Date Posted: June 25, 2006 at 5:27 PM

I always drill it out. If you dont want to drill then I think you need to go to the passanger side to get out. Why wont you drill it out anyways?

-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer

Posted By: patmar
Date Posted: June 28, 2006 at 8:57 PM

the factory wiring on tiburon is under left fender.

pat

Posted By: wentworth007
Date Posted: July 12, 2006 at 10:50 PM

if you try to go through the factory wiring you might end up splicing important wires then you will spend hours trying to fix. just drill a hole.

Posted By: Big Dog
Date Posted: July 21, 2006 at 10:02 PM

For a truly stealth installation, route the underhood wires through the large existing grommet in the drivers kickpad.

It's necessary to remove the left front headlight to receive the harness. Start by removing the 10 retaining screws of the radiator and grill cover.

Then remove the three bolts which hold the headlight in place. Mask the bumper with painters tape then carefully pull the headlight straight out toward you and disconnect the plugs.

You can now pass the underhood wires in the inner fender.

-------------
Prepare your future. It wasn't the lack of stones that killed the stone age.