DEI 530T in a 1997 Mazda 626

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=79704
Printed Date: May 02, 2024 at 5:56 AM

Topic: DEI 530T in a 1997 Mazda 626

Posted By: six2six
Subject: DEI 530T in a 1997 Mazda 626
Date Posted: June 27, 2006 at 9:08 PM

Hey I installed the DEI 530T in a 1997 Mazda 626. With the Aux channel the windows vent and then a second later they roll down all the way. How do stop that? I can't get the to roll up at all. I'm using the lock wire with a relay to boost the signal and I can't even get it to move. It wont even move if I ground the wire. I've tried three different modules and the same problem. Is it something wrong with the wiring? the drivers switch works all the windows and the front two have one touch now.

I can't seem to figure this out. Been at it for two days and I'm ready to pull it out. Any help will be greatly appreciated.

Replies:

Posted By: Big Dog
Date Posted: July 21, 2006 at 10:28 PM

Window goes all the way down instead of venting is because the RED / white of the 530 sees a latched signal rather than a simple trigger whose duration matches the press of a button on the TX or maybe it might be connected to one of the gray wires of the 530 as well. Disconnect gray wire from RED / white.

As for the motor wires, be sure that you connected your wires for the driver's door directly to the motor wires in the driver's door for that window only. They are GREEN/ blue and RED / blue.

All other windows are in driver's kick :

RF Window up/dn	grn/wht - wht/yel	A	drivers door harness
LR Window up/dn	blu/wht - yel/wht	A	drivers door harness
RR Window up/dn	grn/yel - wht/red	A	drivers door harness

-------------
Prepare your future. It wasn't the lack of stones that killed the stone age.

Posted By: six2six
Date Posted: July 23, 2006 at 4:57 PM

Thanks for the reply. The problem is I'm using a compustar and the timed output is 0.5 seconds. I can't change it to anything higher. I've also have the roll up hooked up to the other aux channel. I can't seem to find a ground when armed wire. Can someone point me in the right direction.