commando RS-560 on 88 Camaro
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=79820
Printed Date: May 16, 2025 at 11:52 AM
Topic: commando RS-560 on 88 Camaro
Posted By: eagerinsight
Subject: commando RS-560 on 88 Camaro
Date Posted: July 01, 2006 at 12:06 PM
Just purchased a commando rs-560 and installed all of the alarm and power lock features. Alarm and power locks work great, but when I installed the remote start feature I get nothing? I installed the wiring for the starter output, two 12v inputs, ignition output 1, there is no ignition output 2, and the heater/acc output. I haven't installed anything for the tach signal, brake switch out door pin triggers. When I press start on the remote nothing happens? Do I need to install the other wires, I was told it should start without installing the other wires yet. I tested the wire from the module to the starter output and when I press the start button I don't see any voltage? Any suggestions?
Replies:
Posted By: KarTuneMan
Date Posted: July 01, 2006 at 4:16 PM
Is you car an auto trans? Yes you need the brake and tach....
-------------
Posted By: eagerinsight
Date Posted: July 01, 2006 at 6:06 PM
Yes its auto trans, so it won't work until i hook up the brake and tach?
Posted By: mobilesndfx
Date Posted: July 01, 2006 at 6:16 PM
Yes, you need brake and tach both hooked up. Brake is easy, tach could take some experimenting depending on your alarm and car.
-------------
Alpine 9835, MB Quart components, (3) JL Audio 10w3v2, JL Audio 500/1, JL Audio 300/4, Streetwires wiring
|