Adding LED to factory 2000 Corvette alarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=79965
Printed Date: July 12, 2025 at 10:44 AM
Topic: Adding LED to factory 2000 Corvette alarm
Posted By: j84buick
Subject: Adding LED to factory 2000 Corvette alarm
Date Posted: July 05, 2006 at 8:02 PM
I would like to add a LED to the factory 2000 Corvette alarm. Anyone know where I can pull +12 when the alarm is on?
Replies:
Posted By: j84buick
Date Posted: July 05, 2006 at 8:09 PM
I could not find an edit function but I wanted to add a few things. I see another post very similar to this one. One thing I do understand is how to get a relay and hook it up when the car is turned off. That's pretty cheesy in my opinion. There has to be a way to tell if the factory system is armed....
Posted By: captainzab
Date Posted: July 06, 2006 at 12:37 AM
Aside from it being a vette, i dont think any factory alarm has a wire that gives a pulse when it is armed.
But for the ignition when off LED, i think the relay set up is like:
85 ground, 86 ignition, 87a 12v, 30 red wire of led, also you will need some resistors so that it equals 2v so you dont kill the LED.
Can someone check my relay setup to make sure its right.
|