Clifford Intelliguard 8000
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=80032
Printed Date: May 11, 2025 at 9:03 PM
Topic: Clifford Intelliguard 8000
Posted By: black-n-blue
Subject: Clifford Intelliguard 8000
Date Posted: July 07, 2006 at 4:47 PM
I have the IG8000,,, it is a used system, and I am trying to get into the programming mode, but I only have the unit on my bench until I can verify functionality. I have tried all things I can think of, but I cannot get it to enter programming. So far, I have tried turning key on, enter pin code, then hold the * for 10 seconds. I see on some systems, you have to open a door,,, do I need to open and close a door sensor as well before it will let me in to program it? I ordered my Cliffnet cable, but I don't have it just yet, but I may have to wait for it to get here... Thanks in advance for any assistance!
Replies:
Posted By: swamprat323
Date Posted: July 07, 2006 at 8:12 PM
go to teh down laod section for the install guide, it has program info in it.
Posted By: black-n-blue
Date Posted: July 07, 2006 at 8:27 PM
Did that, still can't get in.... Probably someone has changed the valet code..
Posted By: swamprat323
Date Posted: July 08, 2006 at 6:42 PM
check to see if the atenna is plug it.
Posted By: black-n-blue
Date Posted: July 15, 2006 at 12:15 AM
Got my wizard cable today,,, and as I suspected, the valet code had been changed..... Now that I know what it is, I can tweak everything.... The wizard software is very cool too!!
|