viper 791xv
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=80345
Printed Date: May 10, 2025 at 2:43 PM
Topic: viper 791xv
Posted By: johnmcenroe71
Subject: viper 791xv
Date Posted: July 16, 2006 at 3:52 AM
i need the complete wiring colors and locations to install everything that is possible with the unit in a 96 chevy blazer 4 door. Any help is apriciated but i would like it all. Thank you in advance
Replies:
Posted By: swamprat323
Date Posted: July 16, 2006 at 6:22 AM
| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|red |+ |ignition harness |
| STARTER|purple or yellow |+ |ignition harness |
| IGNITION|pink |+ |ignition harness |
| SECOND IGNITION|white or pink/white |+ |ignition harness |
| ACCESSORY|orange |+ |ignition harness |
| POWER LOCK|lt. blue |+ |either kick panel *2 |
| POWER UNLOCK|white |+ |either kick panel *2 |
| LOCK MOTOR|gray | |drivers kick panel |
| UNLOCK MOTOR|tan | |drivers kick panel |
| DISARM DEFEAT|tan | |passengers kick panel |
| PARKING LIGHTS +|brown | |switch or rear harness |
| HEADLIGHTS|yellow |+ |at switch |
| DOOR TRIGGER|white *3 |- |keyless module *2 |
| DOME SUPERVISION|use door trigger | | |
| TRUNK/HATCH PIN|tied in with doors | | |
|TRNK/HTCH RELEASE|BLACK/ white |+ |switch or keyless *2 |
| TACHOMETER|white | |ECM *1 |
| BRAKE WIRE|white |+ |at brake pedal switch |
| HORN TRIGGER|black |- |steering column |
| WIPERS|purple |+ |left of column |
| LF WINDOW UP/DN|dk. blue - brown |A |in drivers door |
| RF WINDOW UP/DN|dk. blu/wht - tan |A |in drivers door |
| LR WINDOW UP/DN|green - purple |A |in drivers door |
| RR WINDOW UP/DN|lt. green - pur/wht |A |in drivers door |
Notes:
*1 The ECM is located on the passenger inner fender well. Located the white wire in a black plug labeled 'white'. *2 Also found at the TRW keyless entry module mounted to the under dash panel on drivers side. With the module unplugged, the drivers door lock will no longer function. *3 This wire catches all doors, but reads the delay. To keep the alarm from reading the delay, place a diode in-line on the white door trigger wire with the anode towards the keyless module. Attach your door trigger wire to the cathode side of the diode. On non-keyless models there is a module with 5 wires located where the keyless normally resides. The white wire there catches only the front two doors. To catch the rear doors use the white wire at the drivers side rear pin switch.
Posted By: bdl666
Date Posted: July 16, 2006 at 7:28 AM
|