Hi! I have a Hornet 546T installed in my Galant and wanted to add on the remote start. I purchased the 556uw bypass module but have no idea of how to install it and I was hoping someone could help. I would appreciate any help I can get. Thanks in advace.
-------------
ORION_247
you should have an guide in the box. but the wirng is as follows
12v ignition and ground are self explanitory then you should have a blue wire that goes to the ground out from the remote starter and a key sense positve and negative use one purple and green i belive after that is wired the back of the 556u has 4 screws remove and insert a second key into module the other harness with the ring needs to be placed around the key cylinder of the vehicle
hope this helps
-------------
"Computer games don't affect kids, I mean if Pac Man affected us as kids, we'd
all run around in a darkened room munching pills and listening to repetitive
music."-Kristian Wilson, Nintendo Inc.
orion_247 wrote:
Hi! I have a Hornet 546T installed in my Galant and wanted to add on the remote start. I purchased the 556uw bypass module but have no idea of how to install it and I was hoping someone could help. I would appreciate any help I can get. Thanks in advace.
1-You need to scrap one of you key for that bypass (556uw) so you propably purchase a new key for you. You must be install this key in your bypass to complete your installation.
2-You can purchase a bypass have built-in TRANSPONDER (same chip inside the factory key) PATS-MITSUBISHI-1 made by Fortin Electronic Systems. But you need to have dealer SCAN TOOL for programming this unit.
If you planning to purchase a new key you need the dealer SCAN TOOL to program this new key also. But the key is much more expansive than PATS-MITSUBISHI-1.