bmw 316i compact 1997

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=80386
Printed Date: May 02, 2024 at 1:40 PM

Topic: bmw 316i compact 1997

Posted By: bmw97
Subject: bmw 316i compact 1997
Date Posted: July 17, 2006 at 3:23 AM

i bought an aftermarket keyless entry and i want to install it. the car was not pre-wired for alarm\keylesss enrty , is there anybody can help me to locate the cental locking module and where is the lock and unlock wires .

tanx

Replies:

Posted By: 12voltmaster
Date Posted: July 17, 2006 at 1:26 PM

bmw97] wrote:

i bought an aftermarket keyless entry and i want to install it. the car was not pre-wired for alarm\keylesss enrty , is there anybody can help me to locate the cental locking module and where is the lock and unlock wires .

tanx

Check this
https://www.the12volt.com/installbay/forum_posts.asp?tid=80388&PN=1

Posted By: bmwpwner
Date Posted: July 17, 2006 at 11:18 PM

yea, the last 3 series i did had the bcm below the glove box (for lock/unlock) and i grabbed everything else from the column as usual. good luck and hope this helps.

-------------
"I cannot teach anybody anything, I can only make them think."
-Socrates-

Posted By: bmw97
Date Posted: July 18, 2006 at 3:07 AM

tanx for all ur suggestions and help. yesterday i installed my keyless entry on my car and it was successful. How do i do that? i focus on pin 16 &3, i removed the existing wires on pin 16 & 3 and tapped the lock and unlock wires of keyyless entry to the pin 16 & 3 and I soldered diode to each existing wires that i removed and tapped to the ulock and unlock wires (keyless entry) and it works. diode connection is facing away to the existing wires

Print Page | Close Window