Viper 330V problems?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=80539
Printed Date: November 03, 2025 at 7:26 PM
Topic: Viper 330V problems?
Posted By: b1mmuo27
Subject: Viper 330V problems?
Date Posted: July 20, 2006 at 4:25 PM
I installed the above alarm in a friends van last evening & I can't seem to get it working. As soon as I apply power to it the blue led lights up. Tried programming & seem to get the right flashes to acknowledge it's correct, yet the light won't go out. Tried to exit programming mode But the light still stays on. Any ideas? Thanks
Replies:
Posted By: mobilecustoms
Date Posted: July 20, 2006 at 4:46 PM
your in valet mode. get out of it
-------------
Posted By: b1mmuo27
Date Posted: July 20, 2006 at 6:20 PM
Do you mean hold the key in the on position for at least 15 seconds? If not how do I get out of valet mode? Thanks
Posted By: b1mmuo27
Date Posted: July 20, 2006 at 6:34 PM
Tried the open door key in ignition, wait for 15 seconds, turn off. Light still comes on. Idea's?
Posted By: b1mmuo27
Date Posted: July 20, 2006 at 8:09 PM
Checking with my 707T wiring, I may have the blue in H2/4 connected instead of red H2/3. Would the led stay on if that was the case? Thanks
Posted By: swamprat323
Date Posted: July 20, 2006 at 10:36 PM
3 botton remote open door hit locl/unlock then aux then lock/unlock
4 button open door hit lock then unlock then lock again
from key turn igon on then back off hit valet button once all this doen in less then 15 secs
Posted By: b1mmuo27
Date Posted: July 23, 2006 at 9:12 AM
I't only a two button remote. Lock-unlock. Would the alrm refuse to program if the RED -disarm defeat input wan not wired? if so could this be my problem not being able to finish the programming? Thanks
Posted By: b1mmuo27
Date Posted: July 23, 2006 at 2:34 PM
As of this afternoon I rewired the alarm. The existing one in it was an audiovox & I used some of the wiring. Not now. I know all wiring is correct. Programs fine. Panic alarm works if you hit the lock remote button twice. It does not arm. I tried jumping the green H2/2 to 12volts & nothing. Siren works. Pouched? Have I missed something? Here is what is connected:
Main Harness
H1/2-light flash output
H1/5-(-) door trigger
H1/8-ground
H1/10-(+) siren output
H1/11-(+) 12V constant input
Auxillary Harness
H2/2-arm input
H2/3-red disarm defeat input.
That's it.
|