How to remove alarm on honda accord 94

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=80685
Printed Date: July 09, 2025 at 7:31 PM

Topic: How to remove alarm on honda accord 94

Posted By: june8th
Subject: How to remove alarm on honda accord 94
Date Posted: July 24, 2006 at 9:54 AM

Hi.

Since the remote was broken, I have been used the key only during last several months.However, recently the alarm rings sometimes. It is not loud, just little sound. but it's too annoying. If I shutdown and start again several times, then it became silent again.

I'm asking the local mechanic to disable the alarm. They told me that I should ask the dealer who attached the alarm. Unfortunately, I don't know where it is. My car is 12 years old :-(

So, is there anyone who know how to make the alarm silent completely?

Replies:

Posted By: KarTuneMan
Date Posted: July 24, 2006 at 10:57 AM

Drop the bottom of the dash down, find the brain, trace all your wires from the brain and cut'em and tape them up. Chances are, the installer that did the job used T-taps....in that case, unplug em. If your alarm had starter kill, make sure you re-conect this wire after removing the alarm brain. The starter wire is BLACK/ white.

https://www.the12volt.com/installbay/slarmdetail/1033.html

Use this link for referance on your cars factory wire colors.

Posted By: captainzab
Date Posted: July 24, 2006 at 3:37 PM

Most likely the factory installed alarm was done by someone at the dealer. They would have used T Taps and probably a T harness for the 12V and iginition and maybe starter kill. You can simply unhook the T-harness and connect the factory harness together.
T harness look like this

Print Page | Close Window