Print Page | Close Window

Help---Clifford remote learning

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=8095
Printed Date: May 16, 2025 at 1:03 AM


Topic: Help---Clifford remote learning

Posted By: Wess
Subject: Help---Clifford remote learning
Date Posted: January 13, 2003 at 7:14 PM

I have a 1999 suburban and had a clifford alarm installed (in 1999). (Haven't been able to confirm which alarm model was installed, but after comparing features on clifford.com I think it's either a concept 100 or intelliguard 7000. I have a 5 button remote on which the red light stays on whenever you press a button and I also have a 4 button remote that doesn't seem to work at all. I have purchased a new 4 button remote which I can't get programmed. Batteries are all brand new and checked out with a tester. I checked out clifford.com and got the programming instructions for both models . The instructions are the same for both models. When I follow the instructions (enable the valet mode then hold down the * until you hear 1 chirp ...) I NEVER hear the chirp. The fuses have all been checked. CAN ANYONE HELP ME????

Thanks




Replies:

Posted By: 10nesne1
Date Posted: January 13, 2003 at 7:59 PM

https://www.directed.com/guides/manuals/ig/clifford/concept100_install.pdf

save this installation guide and the remote programming is on page 9.

good luck


Print Page | Close Window