compustar 2wss won’t lock

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=80958
Printed Date: May 22, 2024 at 8:27 PM

Topic: compustar 2wss won’t lock

Posted By: bonecutter
Subject: compustar 2wss won’t lock
Date Posted: July 30, 2006 at 9:51 AM

I have an 02 acura rsx and suddenly my compustar won't lock/arm. when I try it beeps 3 times and the remote shows an icon of the door lock pin going up and down. I've looked in tha manual and this icon isn't even listed. I've tried manually locking the doors and it still won't arm, doing the same thing.

Replies:

Posted By: maxcat
Date Posted: July 31, 2006 at 3:00 PM

The icon will either mean that one of your door wires is showing open when you try to arm or you can check your hood pin switch, this may also be in the open position. Make sure you are not getting a signal from any of these wires when tryin to arm the vehicle

Posted By: Velocity Motors
Date Posted: August 01, 2006 at 9:02 AM

Make sure that the AUTO option is not engaged. This is an option that detects the remote control within 50 -75 ft of the vehicle and auto locks and unlocks the car within these parameters. If this is not the case, remove the door trigger harness fromthe CPU and then try to lock the doors. Post your results.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: bonecutter
Date Posted: August 02, 2006 at 1:04 PM

turns out it was the hood. Thanks guys

Print Page | Close Window