Progressive unlocking, Hornet 742T

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=81001
Printed Date: May 15, 2025 at 3:18 PM

Topic: Progressive unlocking, Hornet 742T

Posted By: dbd5000
Subject: Progressive unlocking, Hornet 742T
Date Posted: July 31, 2006 at 11:28 AM

Vehicle - 1998 Ford F150

I have installed the DEI Hornet 742T. Everything is working fine except the manual talks about progressive unlocking (drivers door first than passenger door with a second push of disarm button). The subject shows up under installation options, but does not give any further how-to. Right now they both unlock at the same time. I have cut the pink / YELLOW (power lock) and pink/green (power unlock) and attached the alarm wires for a type C (reversing polarity system) as per the installation guide.

Can this function be accomplished within the unit by changing wires or is it something I need to add a relay for?

Thanks in advance for any input.

dbd

Replies:

Posted By: KarTuneMan
Date Posted: July 31, 2006 at 12:13 PM

Does the unit have a "second unlock" or a "drivers priority" unlock youll need 3 relays one for unlocking the drivers door, one for unlocking the pass. door, and one for locking ALL doors.Check the install manual for a "different" unlock wire. I am NOT a DEI guy, so I do not know off the top of my pea brain. I did some reading, your unit has built in lock relays, thats too bad. Look at one of the 3 aux. outputs see if one of those could be used as a second unlock trigger. I read some more, and it does say in the owners manual Progressive unlocking is an option.....so ther MUST be a seperate trigger for priority unlocking....

Posted By: dbd5000
Date Posted: July 31, 2006 at 1:12 PM

Thanks for the reply

After further looking I found this in the install manual.

If the pic did not come out correctly it says there is (-) second unlock wire.

posted_image

I am not real sure what to do with H3/1 (blue wire). I am assuming I need to run it over the passenger kick panel and cut the unlock wire and attach it there.

Thanks

dbd

Posted By: dbd5000
Date Posted: July 31, 2006 at 1:14 PM

wow

Sorry

That didn't work - can it be deleted?

dbd

Posted By: swamprat323
Date Posted: July 31, 2006 at 11:11 PM

look at page 19 in th einstall guide aux harness has a 2nd unlock wire