2002 ford focus remote start

I just installed a code alarm ca-610 alarm in my focus...the problem im having is when it goes to do the remote start the dash lights will come on but no start...it a se model with the 2.0 engine..anyone have an idea??

Sounds like your car needs a by-pass. According to dirtechs, use the 555s.

-------------
Note: You Always Dont Get What You Pay For.

Is this a manual or automatic vehicle ? If this is an automatic, then ensure that you have the bypass module hooked up correctly and that the starter wire is infact getting 12 volts when cranking.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Stick a key in the ignition, and try the remote starter again.

If it works now, you either failed to install a bypass, or installed or programmed it incorrectly.

I had seen in another forum about the red light above the 4 ways button and it flashes instead of being on constant when the car tries to start...any place special to get the bypass from??

Yeah, the red flashing light is the tipoff-----if it's flashing when the remote start turns on, that's your problem.

How many keys do you have? Please say you have at least two.......you need two existing Ford keys in order to program more of them by yourself......otherwise, you'll need to go to the dealer, or a locksmith with the right equipment.

In any event, two basic ways to do it:

--Buy a commonplace, key-in-the-box style bypass module.......Audiovox AS-TCBM, DEI 556U, bypasskit.com TBKIII are all the same idea. You will LOSE one of your keys; it goes inside the box.

--Go to bypasskit.com and see if they have something that doesn't require you to lose a key.

ok i got the 555 module and connected it..I can program it and it will start with the remote start on the first try after I rogram it..but then when I tried again after placing the sensor in the stearin colum it wont start and the red light flashes again...I can go through programming it again but when i place it in the colum same thing..and ive tried moving it all over inside near the sensor ring but it still wont start...in using a code alarm ca 610 alarm..anyone have an idea as to why im losing my code in the 555?

What kind of "555" are you using? You didn't mention the letter at the end.

If it's the 555F, getting that thing placed just right is a headache, which is why I don't use them.

And I'll bet you're not "losing programming".........don't reprogram anything, but just hold the pellet right in front of the keyhole and try the remote start again.......if it works correctly there, you know it's programmed and working right.

its the 555s...It will work the first time in front of the hole..but if i move it anywhere I get nothing..