Impala, remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=81786
Printed Date: May 04, 2024 at 11:27 AM
Topic: Impala, remote start
Posted By: mexi
Subject: Impala, remote start
Date Posted: August 19, 2006 at 11:08 AM
Ive done a search for a 2006 Impala but still need detailed diagram of how to add a remote start. I have the wiring diagram from dei but has no attachment for how to interface the starter wires. Any info is apreciated.
-------------
mexicang
Replies:
Posted By: wishboneattack
Date Posted: August 19, 2006 at 12:02 PM
Do not use yellow wire...
At EcM:
On the V6 models, the starter wire is in the blue plug, pin 26.
On the V8 models, the starter wire is in the black plug, pin 22.
The ECM (Engine Control Module) is behind the driver side headlight, in the air cleaner assembly.
There is a white wire and a WHITE/ black wire in the ignition harness, or the BCM, green plug, pins 2 and 4, that perform starter, second ignition, and key sense functions. No information at this time, if it is necessary to interface with these wires in addition to the PASS-key III+.
-------------
I may be lost but I am making good time.
Posted By: wishboneattack
Date Posted: August 19, 2006 at 12:13 PM
I just reread the question and see what you are saying now. You are wanting to know if you need to cut the wire for the starter interrupt feature, etc. That is a whole different ball game... I would think it would be the same as usual, unless the ECM is using that wire to initiate a relay that powers the starter and it is negative trigger. Monitor the wire while having someone turn over the vehicle. That should tell you a lot right there.
-------------
I may be lost but I am making good time.
Posted By: mexi
Date Posted: August 19, 2006 at 12:38 PM
I am trying to fiqure out if the same setup for the colorado and ion document#1603 will work on this car. How to make the vehicle remote start? Acording to the document the wire colors are the same. The only problem is that the impala tech sheet does not tell you to use this relay setup to remote start the vehicle.
-------------
mexicang
Posted By: mexi
Date Posted: August 19, 2006 at 12:52 PM
I realize that. This vehicle does not have the typical starting system. One wire performs 3 functions. Similar to the colorado and saturn ion. Can i use the same setup on the impala? ------------- mexicang
Posted By: Chris Luongo
Date Posted: August 19, 2006 at 4:35 PM
You don't need any of that fancy stuff.
Hook up ignition, accessory, and a proper bypass for the PK3+, and you're all set. No need to mess with the white or WHITE/ black wires.
Posted By: mexi
Date Posted: August 19, 2006 at 4:43 PM
Thanks I just fiqured that out alarm and remote start work fine. ------------- mexicang
Posted By: mexi
Date Posted: August 19, 2006 at 4:44 PM
Is it necessary to hook up the keysense wire if using a 556u?
-------------
mexicang
Posted By: Chris Luongo
Date Posted: August 20, 2006 at 2:27 PM
No.
Connect ground, power, and ground-when-running (the blue wire).....leave the others unconnected.
|