Programming remote for avital 2300
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=82068
Printed Date: May 19, 2025 at 2:35 AM
Topic: Programming remote for avital 2300
Posted By: taco1
Subject: Programming remote for avital 2300
Date Posted: August 26, 2006 at 8:56 AM
I had a Avital 2300 alarm put on my car a couple of years ago and i lost the remotes. Well i ordered some new ones off of ebay and i am trying to program them to my alarm. I was curious if anyone had these instructions or could tell me how to do it. I have searched it online and had no luck. Thanks.
Replies:
Posted By: captainzab
Date Posted: August 26, 2006 at 9:35 AM
https://www.avital.com/guides/igs/avital2300_install.pdf
pg 23
Open door
Turn ignition on
Press the Valet button 8 times. Press it once more, but this time hold it.
You should hear 8 chirps.
Press any button on the transmitter (press it atleast twice) ------------- Note: You Always Dont Get What You Pay For.
Posted By: taco1
Date Posted: August 26, 2006 at 11:11 AM
I tried pressing the valet button 8 times then on the 9th holding it but it doesn't chirp at all. Any suggestions? I unplugged the unit and when i plug it back in it starts chirping and the alarm starts sounding. Then i press the valet switch and it cuts the alarm off. But still I tried to press it 8 times and on the 9th nothing.
Posted By: captainzab
Date Posted: August 26, 2006 at 2:52 PM
I think you are in valet mode
Read the install manual it explains how to turn it off and stuff
-------------
Note: You Always Dont Get What You Pay For.
Posted By: taco1
Date Posted: August 28, 2006 at 12:20 PM
Thanks for the help man. I found out that my pin switch on the driver door was messed up therefore the alarm wasn't reading that the door was opened. But now that i have fixed that, the transmiter programs to the alarm but in the install manual it says that channel one works the arm/disarm/panic feature. Well when i program it, the arm button works all 3 options. You press the arm button once and it arms, press it again and it disarms, hold it in and it goes in panic mode. What have i done wrong? Thanks for the help so far.
Posted By: taco1
Date Posted: August 28, 2006 at 12:24 PM
Ok i'm retarded. I wasn't paying attention to channels 5,6,and 7. Thanks for all your help man. This website is the best.
|