alpine 8040 led not working

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=82394
Printed Date: April 30, 2024 at 6:26 AM

Topic: alpine 8040 led not working

Posted By: mg8t7gn
Subject: alpine 8040 led not working
Date Posted: September 02, 2006 at 1:21 PM

Newbie here. I took notice today that the led for my Alpine 8040 doesn't blink. The alarm system itself works. I can arm/disarm it and the siren goes off when I open the door. The last door closed- 10 seconds until it self arms works. I tried another led and it, too, doesn't work. The grounds for both the led and disarm/valet switch appear to be ok. Where would I start to look? Thanks.

Mark

Replies:

Posted By: soundzplusinc
Date Posted: September 02, 2006 at 5:23 PM

welll---

The Old Alpine LED's are 2v - soo use a Meter .. ck it ..

if it has 2v - then the LED is bad ...

Try that

Print Page | Close Window