Print Page | Close Window

2004 Mitsubishi Diagraim

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=82680
Printed Date: May 10, 2024 at 12:26 AM


Topic: 2004 Mitsubishi Diagraim

Posted By: travis n
Subject: 2004 Mitsubishi Diagraim
Date Posted: September 09, 2006 at 9:32 PM

i need a wiring diagram for a 2004 Mitsubishi Eclips. and help would be very helpfull. thanks.

-------------
Trav



Replies:

Posted By: captainzab
Date Posted: September 09, 2006 at 9:49 PM
https://www.directwholesale.net/diagrams/printpage.asp?ModelID=16760&MakeID=32



-------------
Note: You Always Dont Get What You Pay For.




Posted By: travis n
Date Posted: September 09, 2006 at 10:00 PM
thanks, does anyone know what kind of clutch switch the eclipse have????

-------------
Trav




Posted By: captainzab
Date Posted: September 10, 2006 at 12:21 AM
Test it with your DMM.
I think mitsubishi require the connection to be broken inorder to remote start.

-------------
Note: You Always Dont Get What You Pay For.




Posted By: travis n
Date Posted: September 10, 2006 at 11:41 AM
okay, but is it Type 1, Type 2, Type 3, or Type 4. because i never need to cut any wires on any of the clutch switches. just add a relay, or using the second jumper settings in conjunction with a relay to alow any of the following types to remote start. and there is only 4 types. i do this all day long, but i haven't had to do an eclipse yet. and i use a circut protected test light, not a DMM. DMM's are a little less reliable when testing certian circuts. well that is my expereince at least.

-------------
Trav




Posted By: captainzab
Date Posted: September 10, 2006 at 2:35 PM
https://www.the12volt.com/installbay/forum_posts.asp?tid=81756&KW=eclipse

Connect one side of the cut wire to 87a. Connect the other side of the wire to 30. Connect 86 to your ignition wire and 85 to the Compustar black Status out wire in connector 2, pin 2. Make sure you have the ebrake wiring hooked up.

normally open during r/s


-------------
Note: You Always Dont Get What You Pay For.





Print Page | Close Window