Print Page | Close Window |
05 g6 remote startPrinted From: the12volt.comForum Name: Car Security and Convenience Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc. URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=83069 Printed Date: May 14, 2025 at 10:21 AM Topic: 05 g6 remote start Posted By: losboricua Subject: 05 g6 remote start Date Posted: September 18, 2006 at 10:27 PM Hey what else is need to bypass a g6 stock security while installin an alarm/ remote start?? i know i need a 556u for the key but is there anything else needed? i read about the newer gm car havin to talk to the pcm before it start and what not?? thank carlos ------------- 2015 Hyundai Genesis Ultimate Black on Black Tinted Windows, Fogs, Roof Spoiler, ARK Springs, Ruff R1 20's Staggered Replies: Posted By: Velocity Motors Date Posted: September 18, 2006 at 10:40 PM The vehicle requires the ACC to fall out before the starter will crank & the 556UW will do that for you. It's a pretty basic installation other than this.
------------- Jeff Velocity Custom Home Theater Mobile Audio/Video Specialist Morden, Manitoba CANADA Posted By: losboricua Date Posted: September 20, 2006 at 12:19 AM Hey jeff i never bypass a passkey 3 or used a 556u, so is there any tips and trick on what to do. i use the resistor and realy trick to bypass my vats on my monte but i know i have to use the 556u for sure and jsut wondering any thing i should look at. also it the key wires going to be in an orange jacket or what?? Also i read that if i need a wireing diagram that is not in the database just to post for it but i dont wanna have to make a post just for the diagram so hopefully someone can post a diagram for a 05 pontiac g6 base model. thanks a million
p.s. so aslo as all the acc fall right behind the starter wire to the 556u i will be fine right ------------- 2015 Hyundai Genesis Ultimate Black on Black Tinted Windows, Fogs, Roof Spoiler, ARK Springs, Ruff R1 20's Staggered Posted By: jim hunter Date Posted: September 21, 2006 at 9:45 AM no key wires, you need a programmed key( one that will start the car) to place in the 556u, and then you wrap the wring around the ignition switch, this will generate the siganl when relote started so that car sees key transponder
also car has a strange 2nd ign/keysense starter setup, starter wire from remote is not needed car cranks when it senses ignition&acc on then acc drop with proper resistance on WHITE/ white blk wires car will crank, it is a pretty wild system, and most gms have no required starter wires anymore just sees acc drop then it cransk but some have this resistance requirement 12volts RED / white (2A) + ignition harness Starter yel or pur/wh (not for rem st) -,+ PCM, blue plug, pin 23 or 26 Notes: Starter wire is not required for remote start. When the vehicle sees that the ignition wire has voltage and the accessory wire lose voltage, it automatically cranks the starter. The PCM (Powertrain Control Module) is in front of the battery on the driver side fender. Second Starter N/A Ignition pink + ign harn or BCM, C4, pin D3 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Second Ignition N/A Third Ignition N/A Accessory brown + ign harn or BCM, C4, pin C8 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Second Accessory N/A Keysense not required Power Lock white - driver kick or BCM, C1, pin 66 Notes: Lock is a straight negative trigger. Unlock is negative trigger thru a 1.5K ohm resistor. MUST use relays. The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Power Unlock same as power lock wire Lock Motor gray/black to gray 5wi driver kick or BCM, C3, pin A5 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Unlock Motor tan 5wi driver kick or BCM, C3, pin B1 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Parking Lights+ brown + BCM, C3, pin A7 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Parking Lights- BROWN / white - switch or BCM, C2, pin 5 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Hazards white - switch or BCM, C2, pin 9 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Turn Signal(L) lt. blue/white (F), yellow (R) + BCM, C1, pin 38 and C3, pin A9 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Turn Signal(R) dk. blu/wht (F), dk. green (R) + BCM, C1, pin 56 and C3, pin A12 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Reverse Light lt. green + inside rearview mirror Door Trigger gray/black (D), tan/white (P) - each kick or BCM, C1, pins 51 and 72 Notes: Use both wires and diode isolate each. The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Dome Supervision gray - BCM, C3, pin A10 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Trunk/Hatch Pin ORANGE / black - BCM, C1, pin 18 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Hood Pin pink/black - pin switch or BCM, C1, pin 69 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Trunk/Hatch Release BROWN / white - BCM, C1, pin 71 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. The trunk release motor wire is tan/white (+) at the rear fuse block in the driver side of the trunk, black plug, pin F10. Power Sliding Door N/A Factory Alarm Arm factory remote only Factory Alarm Disarm factory remote only Disarm No Unlock with ignition and Passkey Tachometer NOT pink ac any fuel injector Wait to start N/A Brake Wire white + BCM, C1, pin 42 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Parking Brake lt. blue - switch or BCM, C1, pin 59 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Horn Trigger tan - switch or BCM, C2, pin 14 Notes: The BCM (Body Control Module) is part of the fuse/relay box on the front passenger side of the center console. It has the following connectors: C1-72 pin gray plug, C2-72 pin gray plug, C3-41 pin red plug, and C4-68 pin lt. gray plug. Memory Seat 1 N/A Memory Seat 2 N/A Memory Seat 3 N/A Interface Module: Category: Immobilizer Bypass Required: Yes Type: PASS-Key III+ Part #: 556UW Alternate Part1 #: DesignTech 20402 Alternate Part2 #: DesignTech 29402 Notes: Standard on all models. In addition to the bypass module, you will also need to follow the interface information on DirectFax document 1603 using a 1300 ohm resistor. Posted By: jim hunter Date Posted: September 21, 2006 at 9:54 AM start the car with key then cut the white or WHITE/ blue wire, measure resistance between the key side of cut to the WHITE/ blk or WHITE/ yellow wire while cranking( car has anti grind so nothing bad will happen)then wire up 2 relays as follows
relay#1 pin 85 to ground when running on remote start pin 86 to ignition power with diode in line strip ffacing relay pin30 to bcm side of cut wire pin 87a to ignition side of cut wire pin 87 to pin 30 of 2nd relay 2nd realy cont. pin 85 to ground when running pin 86 to starter output wire from remote starter pin 87 put resistor needed in line then hook to WHITE/ blk or WHITE/ yellow wire pin 87a goes to same WHITE/ blk wire after resistor from pin 87 Posted By: losboricua Date Posted: September 21, 2006 at 11:27 PM thanks alot. im waiting for my friend to order the alarm and the 556u
------------- 2015 Hyundai Genesis Ultimate Black on Black Tinted Windows, Fogs, Roof Spoiler, ARK Springs, Ruff R1 20's Staggered |
Print Page | Close Window |