530t window module Modification
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=83108
Printed Date: May 05, 2024 at 6:37 AM
Topic: 530t window module Modification
Posted By: bigman17
Subject: 530t window module Modification
Date Posted: September 19, 2006 at 7:12 PM
I installed 530t's in my car about a month ago and have had the problem of the drivers window never going all the way up. I opened up the 530t and tried to match it to one of the diagrams on the DEI Resistor Modification Instructions but none of the diagrams match what I have. Mine only has to resistors on the board and they are not next to each other. Are these the resistors that i need to change and if so what size resistor is recommended. Thanks
Replies:
Posted By: Velocity Motors
Date Posted: September 19, 2006 at 10:41 PM
You should contact DEI and see if they can help you with this. They will probably require a version number on the module though.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: bigman17
Date Posted: September 20, 2006 at 1:21 PM
I think you have to be a certified installer to get technical help.
Posted By: swamprat323
Date Posted: September 20, 2006 at 1:38 PM
waht the date code of your 530
Posted By: bigman17
Date Posted: September 20, 2006 at 1:50 PM
Posted By: swamprat323
Date Posted: September 20, 2006 at 2:00 PM
place the ground in an another place, also may want to go to a bigger power wire, also were did you tap the power into, of all the 530 ive done only a few i had to open up and change resistors in.
Posted By: ohnelly1978
Date Posted: September 20, 2006 at 3:04 PM
had same problem use the power from directly the battery and adjusted the jumpers on the 530t and it was ok
-------------
ohNelly!
Posted By: bigman17
Date Posted: September 20, 2006 at 7:35 PM
I use a 8 guage right from the battery and it is grounded to a factory bolt. I tried all the dip switchs the resistors definetly need to be changed.
Posted By: auex
Date Posted: September 20, 2006 at 10:31 PM
The diagram you are looking at was meant for the OLDER version of the 530T, the older version would be at least 5 years old. If you have the new board, like you said doesn't match the diagram, then there is no modification to be made. DEI figured it into the current revision of the 530T.
Pretty much start playing with the resistance settings and lube up the track/regulator. Also do NOT ground inside the door.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: bigman17
Date Posted: September 21, 2006 at 7:36 PM
What a bitch, the lovein window should go all the way up. I didnt spend all that time and money to have something wrong with the window. It takes like 4 one touches to get the lover all the way up.
|