2002 Trailblazer

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=8358
Printed Date: May 15, 2025 at 3:00 AM

Topic: 2002 Trailblazer

Posted By: pnr001
Subject: 2002 Trailblazer
Date Posted: January 20, 2003 at 1:29 AM

Just installed a DIY Hornet remote start and a PLDATA in my Trailblazer and everything went fine except that when the truck is remote started and the parking brake is set, the parking lights flash after the truck starts. If the parking brake is released, the headlights will flash after remote start. The parking lights flash once to confirm remote start when you press both buttons. Any ideas... When the key is put in the ignition and turned to the run position, everything goes back to normal. I unlock the car doors before remote start......

Robert

Replies:

Posted By: Chris Luongo
Date Posted: January 20, 2003 at 6:36 AM

The DEI stuff flashes the parking lights on and off while the car is running under remote start......this looks absolutely stupid. Go into programming and change the parking lights to constant.

Posted By: pnr001
Date Posted: January 20, 2003 at 10:12 AM

Thank you Chris. Can you tell me how to get into the programming mode. The instructions don't say.

Thanks, Rob

Posted By: BNLUIS
Date Posted: January 22, 2003 at 8:19 PM

turn key to ignition, turn key off, then press valet switch in the Hornet 4 times then one more time and hold it.(0r 5 times just holit on the last one). then press button 2 on the remote LED will be off. that will set the remote stater for constant parking lights.(LED in the Hornet brain next to the blue valet switch port) if you press button one it will stay on for blinking lights. GOOD LUCK.