remote starter for a 2006 Corolla

Here you go

WIRING INFORMATION - TOYOTA / COROLLA / 2006 / Remote Start

 

12volts  white (25A), black (15A)  +  ignition harness Starter  red  +  ignition harness Second Starter  N/A     Ignition  BLACK/ white  +  ignition harness Second Ignition  BLACK / YELLOW  +  ignition harness Third Ignition  N/A     Accessory  blue/red  +  ignition harness Second Accessory  N/A     Keysense  blue/black  -  ignition harness Notes: Using the status output to trigger this wire during remote start will disarm the factory alarm without unlocking the doors. Power Lock  green  -  driver kick, 10 pin plug Notes: Meter these wires while turning the key in the driver door key cylinder. Power Unlock  blue / YELLOW (double pulse)  -  driver kick, 10 pin plug Notes: Meter these wires while turning the key in the driver door key cylinder. Can also use the passenger door key cylinder wire for unlock, which only requires a single pulse. It is blue/black (-) in the passenger kick in a 10 pin plug. Lock Motor  blue  5wi  driver kick, blue 12 pin plug Unlock Motor  red  5wi  driver kick, blue 12 pin plug Parking Lights+  green  +  driver kick, harness to rear Parking Lights-  GREEN / WHITE  -  headlight switch Hazards  yellow/black  -  flasher relay left of fuse box Turn Signal(L)  GREEN/ black  +  flasher relay left of fuse box Turn Signal(R)  GREEN/ YELLOW  +  flasher relay left of fuse box Reverse Light  RED / black  +  front of fuse box, 10 pin plug Door Trigger  red  -  front of fuse box, 10 pin plug Dome Supervision  use door trigger wire     Trunk/Hatch Pin  RED / white  -  light in trunk Hood Pin  N/A     Trunk/Hatch Release  N/A     Power Sliding Door  N/A     Factory Alarm Arm  arms with lock     Factory Alarm Disarm  disarms with unlock     Disarm No Unlock  use key sense wire     Tachometer  black  ac  ECM, far right plug, pin 5 Notes: The ECM (Engine Control Module) is behind the glove box. On the XRS models, the tach wire is in the second plug from the right, pin 3. Wait to start  N/A     Brake Wire  GREEN / WHITE  +  brake pedal switch Parking Brake  RED / black  -  parking brake switch Horn Trigger  GREEN/ YELLOW  -  horn switch Memory Seat 1  N/A     Memory Seat 2  N/A     Memory Seat 3  N/A     Interface Module: Category: Immobilizer Bypass Required: Yes Type: Transponder Part #: 556UW Alternate Part1 #: DesignTech 20402 Alternate Part2 #: DesignTech 29402 Notes: Standard on all models.

-------------
The Shagmaster
1999 Chevy Suburban 15" lift sittn on 22's sets 7'5"
1992 Chevy Astro Van all Bagged out Dubbed THE SUICIDER
Installing for over 18 years Looking for empolyment NOW send PM for resum

Few tips, on most models the trunk trigger can be found in the drivers kick, bottom plug, RED / white. I've found it easier to get the door trigger in the drivers A pillar, RED / yellow. I've had issues using green as door lock, it makes the locks stop working if armed with a door trigger open. Use blue/white instead in the same plug. The brake wire can be found in the same place they show the park light location. Keysense is not needed even tho there is a security light.

-------------
Mike M2
Tech Manager
CS Dealer Services