Print Page | Close Window

Manual Trans. Car, CS-2011

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=83737
Printed Date: July 17, 2025 at 2:00 AM


Topic: Manual Trans. Car, CS-2011

Posted By: mtxblau
Subject: Manual Trans. Car, CS-2011
Date Posted: October 05, 2006 at 1:52 PM

Everyone's been very helpful before, so I'm hoping for some more help.

I purchased (bulk) three of these CS-2011 alarms. I like them alot, installed them in three (auto) cars, and was going to install it in my scion xB, but the conundrum is that I drive stick, and this is a remote start / alarm system.

So my question is, are there any wires I can *not* connect that would let me use just the alarm feature (I know all the safety issues regarding manuals + remote starts, hence not wanting to do it with this) OR is there a module I can purchase?

A long while back I read about a module that you could add on to an alarm, maybe by DEI, but that thread is long since lost.

If anyone has any info that would help, I'd be very thankful.

Link to the alarm's manual:
https://www.crimestopper.com/techweb/InstructionBooks/ComboSystem/cs2011_4a_2015_25option_ins.pdf



Replies:

Posted By: luis cardona
Date Posted: October 12, 2006 at 10:01 AM

Just dont conect the remote start part (no accesory, no 2nd ignition,no starter output, no brake).

I only conect one power from the alarm because the other one is to supply the accesory , igniton and remota start

but I always install diode in the ignition just in case you press accidentaly the remote you dont power in the ignition part.



-------------
Eng.Luis D.Cardona


Print Page | Close Window