I have a 98 Subaru Legacy Outback with a stock alarm (door locks, starter kill flashing lights etc...) and it needs to be replaced bad. I know where the module is but I am not sure if I just unplug this thing or cut and try to use the existing wires it uses (if that will even work that is). At the least I would need a wiring diagram for the stock alarm. I all ready have one for the wires in the car itself but not for the alarm. If anybody got any tips for me it would be GREATLY appreciated. Thanks.
You can connect wires to it, but you will have to test all the wires. Most of the wires, that I would use from the stock alarm system are door pin, door locks, and ignition wires.
Subaru | Legacy Outback | 1996-1999 |
Remote Starter Wiring Colors and Notes |
Function | | | Vehicle Color | Location |
Start: | | | BLUE/RED | IGNITION SWITCH HARNESS |
Ignition #1: | | | RED | IGNITION SWITCH HARNESS |
Ignition #2: | | | RED / YELLOW | IGNITION SWITCH HARNESS * |
Ignition #3: | | | N/A | |
Accessory: | | | N/A | |
Brake Light: | | | WHITE/ BLACK | AT SWITCH ABOVE BRAKE PEDAL |
Tach Signal: | | | YELLOW/BLUE | AT IGNITER ** |
Parking Lights: | | | BLACK/ GREEN (-) | AT HEADLIGHT SWITCH |
Headlights: | | | BLUE/BLACK (-) | AT HEADLIGHT SWITCH |
OEM Alarm Disarm: | | | WHITE/ GREEN (-) | AT SECURITY MODULE BEHIND GLOVE BOX |
OEM Alarm Arm: | | | | |
Diesel Glow Plug: | | | | |
Clutch Bypass Wire: | | | | |
Notes: | | * Ignition 2 must be programmed to not be "Hot" during crank or a "Check Engine" light will appear in the instrument cluster. ** Ignitor is located at center rear of engine compartment. |
Subaru | Legacy Outback | 1996-1999 |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | | Vehicle Color | Location |
Constant +12 Volts: | | | BLACK / YELLOW | IGNITION SWITCH HARNESS |
Starter Kill: | | | BLUE/RED | IGNITION SWITCH HARNESS |
Ignition +12 Volts: | | | RED | IGNITION SWITCH HARNESS |
Dome Lights/Superv: | | | RED / WHITE (-) | AT DOME LIGHT OR COMB. METER |
OEM Horn: | | | RED / GREEN (-) | STEERING COLUMN HARNESS |
Power Lock: | | | WHITE/ RED (-) | AT TIMER MOD. BEHIND RT. SIDE DASH *** |
Power Unlock: | | | WHITE (-) | AT TIMER MOD. BEHIND RT. SIDE DASH *** |
Trunk Release: | | | N/A | |
Alarm Input Wire: | | | RED / WHITE (-) | AT DOME LIGHT OR COMB. METER |
Notes: | | *** See Note #201 Negative Pulse Door Lock Diagram |
Whoooooh. Thanks 10nesne 1!! That is exactly what I needed!