remote start problems
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=84259
Printed Date: May 17, 2025 at 11:33 PM
Topic: remote start problems
Posted By: rizay94isuzu
Subject: remote start problems
Date Posted: October 17, 2006 at 6:23 PM
i have a 94 isuzu pup, and have installed an alarm with remote start made by phonics digital .the remote start was a sucsess but will only run for a short while. when i remote start the starter stays engaged for as long as it runs any suggestions
-------------
raymond
Replies:
Posted By: sparkie
Date Posted: October 17, 2006 at 6:29 PM
It sounds like the unit either isn't receiving a tach signal or you haven't programmed the tach signal to the remote starter. I am not famaliar with your unit, but many units are designed to crank the engine for 8 seconds or so and quit or until the remote starter senses that the engine has reached the correct RPM and then it will disengage the starter. You could also have some of the wires mixed up. You could have reversed the ignition and starter wires. Post your model of Isuzu to let members help you more effectively.
-------------
sparky
|