Hey guys, It seems that I am doing more alarm work now, Once I do one all my friends/neighbors want something done too. Lol
Anyways, looking for some detailed guidance please!! 2003 Chevy Silverado 1500HD 4 door fully loaded. Autopage 860LCD, GMDL-BP.even thinking about this...
https://cgi.ebay.com/dll?ViewItem&rd=1&item=150039734241&ssPageName=STRK:MEWA:IT&ih=005
I have installed alarms,remote start, & various accessories, even a few transponders but never a bypass kit. Please if someone could line out what I need to do so I can get this one done correctly!
Thanks, Greg
The GMDL-BP is very easy to use. For a remote start appliction only, hook up the brown to the negative out when running from your remote starter, the blue and green door lock/unlock wires to the corresponding wires from the remote starter. Hook the red wire to a fused source of battery power and the ground to a good chassis ground. Connect the violet wire from the bypass to the violet wire at the vehicle diagnostic plug under the driver's side dash. Program the module to mode 4. Then finish the programming instructions. It doesn't get much easier than this. Just review the instructions a few times before programming it. There is no need to rush. If you want all the doors to unlock at the same time, program option 1 for this as it isn't the default setting.
-------------
sparky
any difference if the remote start is an alarm too?
Thanks!! Greg
should be a door trigger output (pink I think) on the gmdl bp... on some gm's if it's a crew cab ya still need to pull a trigger for the rear door pins of the truck itself.. not the bypass... I think there is a dome lite output too on the gmdlbp... It's all in the destructions....
-------------
Tire Proz Stillwater Mn
High End Restyling and Comlete Repair