2006 Avalon, remote start?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=84391
Printed Date: May 13, 2025 at 10:09 PM
Topic: 2006 Avalon, remote start?
Posted By: mobilecustoms
Subject: 2006 Avalon, remote start?
Date Posted: October 20, 2006 at 3:15 PM
Can a remote start be added to a 2006 toyota avalon limited with the smart key- no hybrid. gas only car? How do i bypass the smart key? Does anybody have a wiring diagram?
thanks
-------------
Replies:
Posted By: gcorrea
Date Posted: October 20, 2006 at 9:36 PM
DIRECTWIRE™ WIRING INFORMATION - TOYOTA / AVALON / 2006 / Remote Start
[PRINT THIS PAGE]
12volts black (30A), orange (7.5A) + ignition harness
Starter blue + ignition harness
Second Starter red + ignition harness
Ignition yellow + ignition harness
Second Ignition green + ignition harness
Third Ignition N/A
Accessory gray + ignition harness
Second Accessory N/A
Keysense black - ignition harness
Notes: Using the status output from the remote start to trigger this wire will disarm the factory alarm without unlocking the doors.
Power Lock black to brown - driver kick, 20 pin plug, pin 9
Notes: Meter this wire while turning the key in the driver door key cylinder.
Power Unlock gray to purple (double pulse) - driver kick, 20 pin plug, pin 19
Notes: Meter this wire while turning the key in the driver door key cylinder.
Can also use the passenger door key cylinder wire, which only requires a single pulse. It is gray to yellow (-) in the passenger kick, 20 pin plug, pin 8.
Lock Motor red to white 5wi driver kick, 20 pin plug, pin 1
Unlock Motor white to gray 5wi driver kick, 20 pin plug, pin 20
Parking Lights+ do not use, relay rests at gnd
Parking Lights- blue - headlight switch
Hazards yellow - switch or turn signal flasher, pin 8
Notes: The turn signal flasher is under the driver side dash, against the firewall.
Turn Signal(L) black + turn signal flasher, pin 3
Notes: The turn signal flasher is under the driver side dash, against the firewall.
Turn Signal(R) pink + turn signal flasher, pin 2
Notes: The turn signal flasher is under the driver side dash, against the firewall.
Reverse Light pink to black + driver kick, 17 pin plug, pin 2
Door Trigger see notes - each kick, harness to rear
Notes: The LF door is pink to blue, RF door is purple to blue, LR door is black, and RR door is gray. Use all four wires and diode isolate each.
Dome Supervision brown - R side of fusebox, 12 pin plg, pin 5
Trunk/Hatch Pin white to purple - driver kick, blu 20 pin plug, pin 17
Hood Pin blue - pin switch under hood
Trunk/Hatch Release blue - trunk release switch on dash
Notes: The trunk release motor wire is black (5wi) in the driver kick, blue 20 pin plug, pin 11.
The fuel lid release is gray to green (+) at the release switch on the dash or in the driver kick, blue 20 pin plug, pin 15.
Power Sliding Door N/A
Factory Alarm Arm arms with lock
Factory Alarm Disarm disarms with unlock
Disarm No Unlock use key sense wire
Tachometer white ac ECM, second plug from top, pin 1
Notes: The ECM (Engine Control Module) is behind the glove box.
Can also go to any fuel injector and use the wire that is NOT brown.
Wait to start N/A
Brake Wire white + brake pedal switch
Parking Brake lt. green - parking brake switch
Horn Trigger gray - horn switch in column cover
Memory Seat 1 green - memory seat switch in door
Memory Seat 2 purple - memory seat switch in door
Memory Seat 3 N/A -
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Transponder
Part #: 556UW
Alternate Part1 #: DesignTech 20402
Alternate Part2 #: DesignTech 29402
Notes:
Smart Starter Kill Relays: Not Available
warning
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
gcorrea
Posted By: Velocity Motors
Date Posted: October 21, 2006 at 9:58 AM
I have not worked on this vehicle yet but this is what I've heard, take apart the key fob and put a relay on the battery and tie in the fob to the unversal bypass module and it will start.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: chadwa2003
Date Posted: October 21, 2006 at 10:50 AM
Hello Jeff Can you elaborate on this set-up you have reffered to? What do you mean by "take apart the key fob and put a relay on the battery and tie in the fob to the unversal bypass module and it will start"?
Posted By: Chris Luongo
Date Posted: October 21, 2006 at 7:05 PM
Have you used the search feature? All of the information you seek should be able to be found here, as well as at the Security forum at carsound.com/forum
|