Clifford RSX 3.5 R/S Issues

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=84437
Printed Date: May 14, 2025 at 1:31 AM

Topic: Clifford RSX 3.5 R/S Issues

Posted By: alienhemi
Subject: Clifford RSX 3.5 R/S Issues
Date Posted: October 21, 2006 at 7:20 PM

Good evening 12V experts, I come this forum hopefully for some resolution!

I have used the search function extensively with negative results.

I have a 2006 Dodge Ram 1500 Hemi (FIRST MISTAKE IN ALARM INSTALL 101) and installed the Clifford RSX 3.5 the other day.

Included in this install is the 530T / 508D / 556

Everything works except for this little nagging problem, when I remote start the truck and then get in and turn key on and disengage the alarm I get idiot lights like crazy!! Including the "ABS" and "BRAKE" light. Now start the truck with regular key no problems at all..

I did see something about a Diesel Install that mentioned idiot lights; however I did not know if that applied to this application..

Any help would be great.. Look forward to learning a lot from you folks..

Alien..

Replies:

Posted By: cntrylvr79
Date Posted: October 21, 2006 at 11:43 PM

Sounds like you might not have all of the ignition wires powered up, or they're not being powered at the right time.

12volts	lt. blue/red (2A)	+	ignition harness
Starter	dk. GREEN/ YELLOW	+	ign harn or starter button (SRT-10)
Second Starter	PURPLE / brown	-	ignition harness
Notes: The second starter wire is negative trigger thru an 180 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information.
Ignition	pink/white	+	ignition harness
Second Ignition	N/A
Third Ignition	N/A
Accessory	same as second starter wire	-	ignition harness
Notes: The accessory wire is negative trigger thru a 610 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information.
Second Accessory	N/A

You're second starter and second accessory wires how did you tie into them? Like it says in the document in the link below?

https://www.directechs.com/techtips/pdfs/resources/security/directed_techtips/1084.pdf

If not I would start with those as the problem with your idiot lights

-------------
Cause I'm So white and nerdy...
First Class Certi-fried installer

Posted By: alienhemi
Date Posted: October 21, 2006 at 11:47 PM

Yes the installer followed the TECHTIP1084 document, I was sitting in the passenger seat like an annoying customer would.. LOL

But yeah I watched him hook up two relays and all, he is going to call DEI on monday; however I was hoping to get some good answers here first..