prostart 3460 tachometer programing
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=84446
Printed Date: May 15, 2025 at 8:23 AM
Topic: prostart 3460 tachometer programing
Posted By: nfekho
Subject: prostart 3460 tachometer programing
Date Posted: October 21, 2006 at 11:49 PM
i have a prostart 3460 dual communication remote starter i am installing it in a 1992 golf manual -i am not able to program the tachometer either in the first mode conventional tach programing or the or multi speed tah programing .i changed 3 module and the same problem first time after programing the starter works for 5 times correctly the engin starts by remote and stops by remote and after that it starts and keep on cranking so i stoppet it and after that forget it you cannot re program the tach --secong one worked for 2 days and then over cranked and did the same problem ---the 3rd one did not learn the tach and i wonder what to do -i have a good groud directly frome battery to module -any one had a similar problem ?????????
Replies:
Posted By: Velocity Motors
Date Posted: October 22, 2006 at 2:23 AM
Is the Golf a diesel or gas engine ? Also post where you grabbed the tach wire from along with wire color.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: nfekho
Date Posted: October 22, 2006 at 7:26 AM
no it is not a diesel and i put the tach on the negative side of the coil on idle i have 5.8 v ac the ground is 0.6 ohm i tested all the cables no luck --------
Posted By: Velocity Motors
Date Posted: October 22, 2006 at 5:04 PM
Was the wire you connected it to GREEN ?
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: nfekho
Date Posted: October 22, 2006 at 6:29 PM
no the wire was black and red today i tryed one more time it worked but my rpm was at 1000to 1100rpm i do not know if it is gonna make the same problem again because off the rpm some time it is not stady do not forget it is 1992
|