hey guys its me again and im at it with another crown victoria i installed an alarm on one a couple months ago and gad some problems at the beggining but solved them the only problem i coudl not fix was that i could not get the alarm to go into passive arming but the customer was fine with that. now i have the same problem again with another 98 crown vic. everything works perfectly fine except that i can not get it to go into pasive ariming any ideas?
by the way its a 98 ford crown vic
the alarm is a mearlon e330
-------------
i know some stuff and what i dont know ill make it up feel free to ask
hey guys its me again i have one question on that same crown vic (98) with the mearlon e330 i had a fuse blow but im not sure what caused. its the fuse for the 12v wire inside the car the one at the ignition switch harness when i put the alarm inn the car i grabed power 12v from there for 3 rellays (2 for the lock and unlock and the one for the starter kill) and the alarm and everything works fine the thing is that the car had a loose batt terminal and they still drove it like that so i am wondering what caused the fuse to blow did i over load that system or did the false contact caused by the batt terminal being loose cause it
thanx in advance for the help
-------------
i know some stuff and what i dont know ill make it up feel free to ask
hey guys hope you can help me out here im still trying to grt this alarm to work ok i got two rellays and ran a fused wire to terminals 87 and 86 on both relays then i cut the pink and green wire from the switch and connected those wires to terminals 30 and 87a but when i go to put the fuse in it blows right away i was told to do it like that its just that i dont want to bother the guy that helped me on this thats why i need help
-------------
i know some stuff and what i dont know ill make it up feel free to ask