Print Page | Close Window

2004 Ford F450 Diesel

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=84972
Printed Date: May 13, 2025 at 7:59 AM


Topic: 2004 Ford F450 Diesel

Posted By: dereck
Subject: 2004 Ford F450 Diesel
Date Posted: November 01, 2006 at 7:15 PM

Looking for wiring info for a 2004 Ford F450 Diesel, for remote starter instalation. Thanks



Replies:

Posted By: Twelvoltz
Date Posted: November 01, 2006 at 9:06 PM

DIRECTWIRE™ WIRING INFORMATION - FORD / F SERIES SUPER DUTY / 2004 / Remote Start

[PRINT THIS PAGE]

12volts      yellow & lt. GREEN/ purple       +       ignition harness
Starter      green       +       ignition harness
Second Starter      N/A            
Ignition      RED / lt. green or WHITE/ yellow       +       ignition harness
Second Ignition      N/A            
Third Ignition      N/A            
Accessory      gray / YELLOW & RED / black       +       ignition harness
Second Accessory      blue/lt. green       +       ignition harness
Keysense                 
Power Lock      see notes            
Notes: Without keyless entry use pink / YELLOW for lock and pink/lt. green for unlock. They are 5 wire reverse polarity mastered from the driver switch and found in either kick panel. With keyless entry use WHITE/ red for lock and BLACK/ white for unlock. They are negative trigger and found at the VSM.

On the vehicles with keyless entry the GEM shuts down after the doors have been locked for a certain time period, to wake up the system refer to DirectFax document 1094.
Power Unlock      see power lock notes            
Lock Motor      pink/black       5wi      VSM
Notes: The VSM (Vehicle Security Module) is to the right of the accelerator pedal above the transmission hump below the radio. Not accessible from radio opening.
Unlock Motor      RED / orange       5wi      VSM
Notes: The VSM (Vehicle Security Module) is to the right of the accelerator pedal above the transmission hump below the radio. Not accessible from radio opening.
Parking Lights+      brown       +       headlight switch
Parking Lights-      N/A            
Hazards      same as turn signals            
Turn Signal(L)      lt grn/wht (F), lt grn/org (R)      +       steering column
Turn Signal(R)      wht/lt blu (F), org/lt blu (R)      +       steering column
Reverse Light      BLACK/ pink       +       fuse box
Door Trigger      BLACK/ lt. blue       +       passenger kick panel
Dome Supervision      use door trigger            
Trunk/Hatch Pin      N/A            
Hood Pin      N/A            
Trunk/Hatch Release      N/A            
Power Sliding Door      N/A            
Factory Alarm Arm                 
Factory Alarm Disarm                 
Disarm No Unlock                 
Tachometer      NOT RED / lt. green       ac       any ignition coil
Notes: On diesel vehicles the tach wire is GREEN / WHITE in a 5 wire harness held up with white tape behind the parking brake release.
Wait to start      see DirectFax document 1091            
Notes: On the remote start, make sure to program the Accessory State During Wait To Start to ON.
Brake Wire      lt. green       +       brake pedal switch
Parking Brake      lt. GREEN/ red       -       parking brake switch
Horn Trigger      blue       -       steering column or VSM
Notes: The VSM (Vehicle Security Module) is to the right of the accelerator pedal above the transmission hump below the radio. Not accessible from radio opening.
Memory Seat 1      BROWN / lt. green       -       memory mod under dr seat
Memory Seat 2      BLACK/ orange       -       memory mod under dr seat
Memory Seat 3      N/A       -      
Interface Module:      Category:
Immobilizer Bypass      Required:
No      Type:
N/A
Part #: N/A
Notes:
Smart Starter Kill Relays: Not Available


warning      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.






Posted By: dereck
Date Posted: November 02, 2006 at 5:32 PM
Thanks, now the wait to start, what wire is that or how do i get DirectFax document 1091?




Posted By: Twelvoltz
Date Posted: November 02, 2006 at 6:03 PM
1091 is a diagram of how to use a 528T, which is just a pulse timer. Just check your installation manual and see if it has a diesel mode, all of the new DEI product (atleast what I have seen) has a menu programmable option to delay the starter for a preset amount of time. What is the make and model of your starter?





Print Page | Close Window