valet 712t into a 2004 dodge truck

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=85174
Printed Date: July 12, 2025 at 10:41 AM

Topic: valet 712t into a 2004 dodge truck

Posted By: wardyl
Subject: valet 712t into a 2004 dodge truck
Date Posted: November 05, 2006 at 5:16 PM

I just installed a new starter in my 98 Expedition, due to failure. When i changed this out I had to disconnect the battery. Since I have done this the DEI Valet 561r starter isn't working do i need to relearn the transmitter like original. Or is there something wrong with my remote start?

Thanks

Warren

Replies:

Posted By: brucewayne
Date Posted: November 05, 2006 at 5:16 PM

2004 dodge truck

single wire system (ground - )

I have never installed a internal relay setup

I need a ground output for both lock and unlock. I already have the proper resistor setup to work just need to figure out the alarm output.....

the lock common output 30, lock nor closed 87, lock open 87(input) ; where do they go

unlock 30 common output, unlock 87 nor open 87 input ; where do they go

thanks in advance, I cant figure this out

Peter

Posted By: Twelvoltz
Date Posted: November 05, 2006 at 5:20 PM

Ward, did you make sure to ground the BLACK/ white wire on the DEI piece? This wire is a neutral safety wire which is not needed on your Expedition. If this wire does not see a ground the starter will not engage.

BruceWayne, you need to start your own thread...do that and someone will answer.

Posted By: brucewayne
Date Posted: November 05, 2006 at 5:20 PM

do i wire the purple (87 normally open)to a ground and then the unlock/lock 30 to the unlock /lock wire

Posted By: brucewayne
Date Posted: November 05, 2006 at 5:23 PM

Twelvoltz wrote:

Ward, did you make sure to ground the BLACK/ white wire on the DEI piece? This wire is a neutral safety wire which is not needed on your Expedition. If this wire does not see a ground the starter will not engage.

BruceWayne, you need to start your own thread...do that and someone will answer.

I did the title of this thread says dodge truck in it???? I dont know how the expedition post got in there

Posted By: brucewayne
Date Posted: November 05, 2006 at 5:52 PM

figured it out, using the other posts in this forum WOOHOO

Posted By: Twelvoltz
Date Posted: November 05, 2006 at 7:01 PM

That is odd, must have been a glitch with the site.

Glad to hear you got it working!