Print Page | Close Window

1997 camry tach programming probleme

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=85184
Printed Date: July 13, 2025 at 1:45 PM


Topic: 1997 camry tach programming probleme

Posted By: soner
Subject: 1997 camry tach programming probleme
Date Posted: November 05, 2006 at 7:11 PM

hi,I have a 1997 toyota camry 2.2 lt. and I installed prostart 3200 remote starter. All wiri installation is good I verify them maybe 10 times but when I start my car by the remote starter car start and after 5 second it's stop and it does that 3 times and it's stay stop and when it's start each time starter solenoid stay on all the time.but Ithing my probleme is tuch signal programing I try to programing maybe 20 times I'm going crazy now.I put my tuch signal wiri on ECM blk/org wiri.I change jumper for high and low tuch signal but no different.ground is very good I put it on battery ground.please help me..thnak you..



-------------
soneraydin



Replies:

Posted By: chris354
Date Posted: November 05, 2006 at 8:47 PM
TOYOTA, CAMRY, 1997, Tachometer

On the 4 cylinder motor use the black wire in the gray plug at the coil on the drivers side of the motor. On the 6 cylinder motor use the gray wire located at the ignitor on a bracket just in front of the strut tower. The module says Denso on it.


Print Page | Close Window