2006 dodge ram Alarm/RS
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=85266
Printed Date: October 31, 2025 at 3:03 AM
Topic: 2006 dodge ram Alarm/RS
Posted By: mugpar
Subject: 2006 dodge ram Alarm/RS
Date Posted: November 06, 2006 at 11:40 PM
I just put a Clifford matrix responder 3.5 into a 2006 dodge ram, with a 556u bypass. The alarm function works fine. The RS doesn't. I put in the relays for acc/2nd start. I programmed tach. When you hit the button to start, there is no acknowledgment on the remote, but when you set alarm, the remote confirms. The truck arms/disarms fine, just doesn't start, no crank, nothing. I tested every wire, everything is hooked up correctly. Any ideas?
Replies:
Posted By: BulletTooth
Date Posted: November 07, 2006 at 1:16 AM
Make sure that the Neutral Safety check wire is connected properly, and that your hood pin wire is not grounded.
Posted By: mugpar
Date Posted: November 08, 2006 at 12:31 AM
Checked both of those, I have not hooked up the hood switch, so that's not grounded. The neutral safety wire, meaning the kill switch?
Posted By: green6767
Date Posted: November 08, 2006 at 9:06 PM
Is the remote starter powering up the accessory/ignition wires? Is it just not powering up the starter wires? Where did you go for power? Explain what exactly the truck does/doesn't do when attempting to remote start.
-------------
Shaun, we are the same height, that is neat!
12V Installation Technician for Honda, Dodge, Chrysler, Toyota and Jeep.
Posted By: jacked93
Date Posted: November 11, 2006 at 8:47 PM
did you get this figured out, i am having the same problem
Posted By: Mike M2
Date Posted: November 12, 2006 at 8:34 AM
mugpar wrote:
Checked both of those, I have not hooked up the hood switch, so that's not grounded. The neutral safety wire, meaning the kill switch?
He means the BLACK/ white wire on plug H3. It must be grounded for the RS to do anything at all.... ------------- Mike M2
Tech Manager
CS Dealer Services
|