Print Page | Close Window

07 mazda cx-7 alarm/radio

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=85374
Printed Date: March 28, 2024 at 10:19 AM


Topic: 07 mazda cx-7 alarm/radio

Posted By: Z-MAN
Subject: 07 mazda cx-7 alarm/radio
Date Posted: November 09, 2006 at 12:00 AM

Just seeing if anyones got these diagrams yet( alarm/radio) and if so, could I please get any info for this veh. Thanks



Replies:

Posted By: Mike M2
Date Posted: November 09, 2006 at 6:54 AM
12volts red (40A), red (40A)  +  ignition harness
Starter gray/red  +  ignition harness
Second Starter N/A    
Ignition GREEN/ YELLOW  +  ignition harness
Second Ignition N/A    
Third Ignition N/A    
Accessory pink / YELLOW  +  ignition harness
Second Accessory yellow  +  ignition harness
Keysense RED / black or BROWN / green  +  ign harn or BCM, 24 pin plug, pin 3C
Notes: The BCM (Body Control Module) is high in the driver kick.
Power Lock GREEN/ red to BLACK/ blue  -  dr kick or BCM, 30 pin plug, pin 5M
Notes: Lock is negative trigger thru a 1000 ohm resistor. Unlock is a straight negative trigger. MUST use relays.

The BCM (Body Control Module) is high in the driver kick.
Power Unlock same as power lock wire    
Lock Motor yellow/black  5wi dr kick or BCM, 6 pin plug, pin 6E
Notes: The BCM (Body Control Module) is high in the driver kick.
Unlock Motor WHITE/ red to WHITE/ black  5wi dr kick or BCM, 6 pin plug, pin 6C
Notes: The BCM (Body Control Module) is high in the driver kick.
Parking Lights+ RED / blue  +  driver kick, harness to rear
Parking Lights- BLACK/ red  -  headlight switch, pin L
Hazards BLACK/ orange  -  switch or BCM, 24 pin plug, pin 3J
Notes: The BCM (Body Control Module) is high in the driver kick.
Turn Signal(L) blue  +  dr kick or BCM, 30 pin plug, pin 5R
Notes: The BCM (Body Control Module) is high in the driver kick.
Turn Signal(R) blue/red  +  dr kick or BCM, 30 pin plug, pin 5O
Notes: The BCM (Body Control Module) is high in the driver kick.
Reverse Light GREEN/ orange  +  driver kick, harness to rear
Door Trigger see notes  -  BCM, 30 pin plug
Notes: The LF door is BLACK / YELLOW in pin 5Y. The RF door is BLACK/ blue in pin 5V. The LR door is BLACK/ orange in pin 5S. The RR door is BLACK/ green in pin 5T. Use all four wires and diode isolate each.

The BCM (Body Control Module) is high in the driver kick.
Dome Supervision BLACK/ blue  -  dr kick or BCM, 6 pin plug, pin 6B
Notes: The BCM (Body Control Module) is high in the driver kick.
Trunk/Hatch Pin BLACK/ red  -  dr kick or BCM, 30 pin plug, pin 5P
Notes: The BCM (Body Control Module) is high in the driver kick.
Hood Pin BLACK / YELLOW  -  pin sw or BCM, 16 pin plug, pin 1A
Notes: The BCM (Body Control Module) is high in the driver kick.
Trunk/Hatch Release N/A    
Power Sliding Door N/A    
Factory Alarm Arm BLACK/ white  -  dr kick or BCM, 30 pin plug, pin 5A
Notes: Meter this wire while turning the key in the driver door key cylinder.

Arm is negative trigger thru a 1000 ohm resistor. Disarm is a straight negative trigger. MUST use relays.

The BCM (Body Control Module) is high in the driver kick.
Factory Alarm Disarm same as factory alarm arm wire   
Disarm No Unlock     
Tachometer GREEN/ stripe  ac  any fuel injector
Notes: Can also go to any ignition coil and use the wire that is NOT green or BLACK/ blue.
Wait to start N/A    
Brake Wire RED / white  +  brake pedal switch or driver kick
Parking Brake BLACK/ red  -  switch or BCM, 16 pin plug, pin 1C
Notes: The BCM (Body Control Module) is high in the driver kick.
Horn Trigger black  -  switch or BCM, 24 pin plug, pin 3H
Notes: The BCM (Body Control Module) is high in the driver kick.
Memory Seat 1 N/A    
Memory Seat 2 N/A    
Memory Seat 3 N/A    
posted_image
Interface Module:Category:
Immobilizer Bypass
Required:
Yes
Type:
Transponder
Part #: 556UW


-------------
Mike M2
Tech Manager
CS Dealer Services




Posted By: Z-MAN
Date Posted: November 09, 2006 at 9:05 AM
Thanks mr. Mike..I'll check it out. posted_image




Posted By: Z-MAN
Date Posted: November 29, 2006 at 8:38 PM
will the 556U work for this install on the remote start. Thanks for any info you might have!




Posted By: jasondavis05
Date Posted: December 05, 2006 at 12:42 AM

Yes Mike M2 has it there at the bottom

Interface Module:Category:
Immobilizer Bypass
Required:
Yes
Type:
Transponder
Part #: 556UW






Print Page | Close Window