Only if your rs unit doesn't have them built in.. need resistors though....
-------------
Tire Proz Stillwater Mn
High End Restyling and Comlete Repair
Here is what DEI lists for the Charger
DIRECTWIRE™ WIRING INFORMATION - DODGE / CHARGER / 2006 / Remote Start
[PRINT THIS PAGE]
12volts lt. blue/red (15A) + ignition harness
Starter pink/dk. green + ignition harness
Second Starter PURPLE / brown - ignition harness
Notes: The second starter wire is negative trigger thru an 180 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information.
Ignition pink/white + ignition harness
Second Ignition
Third Ignition
Accessory same as second starter wire - ignition harness
Notes: The accessory wire is negative trigger thru a 610 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information.
Second Accessory
Keysense
Power Lock PURPLE / dk. green - DKP or cluster, gry 26P plug, pin 5
Notes: Lock is negative trigger thru a 330 ohm resistor. Unlock is negative trigger thru a 100 ohm resistor. MUST use relays.
Power Unlock same as power lock wire
Lock Motor lt. green 5wi DKP or cluster, gry 26P plug, pin 12
Unlock Motor tan/lt. green 5wi DKP or cluster, gry 26P plug, pin 11
Parking Lights+ WHITE/ purple + pass. kick, brn 26 pin plug, pin 26
Parking Lights- WHITE/ brown - sw or cluster, gry 26P plug, pin 3
Notes: Parking lights are negative trigger thru an 1,670 ohm resistor. There is a rest resistance on the wire, so must use a relay to isolate from the switch.
Hazards WHITE/ dk. blue - hazard switch
Turn Signal(L) use hazards wire
Turn Signal(R) use hazards wire
Reverse Light WHITE/ lt. green + pass. kick, brn 26 pin plug, pin 17
Door Trigger see notes - each kick or instrument cluster
Notes: The LF door is purple in the white plug, pin 3. The RF door is PURPLE / white in the white plug, pin 16. The LR door is PURPLE / gray in the gray 26 pin plug, pin 10. The RR door is purple / YELLOW in the gray 26 pin plug, pin 9. Use all four wires and diode isolate each.
Dome Supervision yellow/white + instrument cluster, wht plug, pin 12
Notes: Also found in the passenger side A pillar.
Trunk/Hatch Pin PURPLE / orange - PKP or cluster, gry 26P plug, pin 23
Hood Pin PURPLE / lt. blue (export only) - pin switch under hood
Trunk/Hatch Release PURPLE / tan - sw or cluster, gry 26P plug, pin 22
Notes: The trunk release motor wire is tan / YELLOW (5wi) in the passenger kick or instrument cluster, white plug, pin 24.
Power Sliding Door N/A
Factory Alarm Arm arms on lock with door open
Factory Alarm Disarm factory remote only
Disarm No Unlock with ignition and Sentry Key
Tachometer NOT BROWN / yellow ac any ignition coil or fuel injector
Wait to start N/A
Brake Wire dk. GREEN / WHITE + brake pedal switch
Parking Brake gray/black - sw or cluster, gry 26P plug, pin 18
Horn Trigger dk. GREEN/ orange + horns under hood
Memory Seat 1 PURPLE / brown - memory switch in driver door
Notes: Memory seats are negative trigger thru resistors. The resistor values are not known at this time. Cut the wire and meter the values as you press the memory 1 and memory 2 buttons.
Memory Seat 2 same as memory seat 1 wire -
Memory Seat 3 N/A -
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Sentry Key
Part #: 556CW
Alternate Part1 #: DesignTech 29402
Alternate Part2 #: 556UW
Alternate Part3 #: DesignTech 20402
Notes: Standard on all models.
Interface Module: Category:
Door Lock Interface Required:
No Type:
Multiplex
Part #: 456LW
Notes:
Interface Module: Category:
Combo Interface Required:
No Type:
Data Bus
Part #: IOM-Chrysler-7
Notes:
Smart Starter Kill Relays: Relay Type:
Starter Relay Location:
Engine compartment fusebox, Driver side
Part #: 6401A
warning
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
This car has a unique second starter/accessory wire that requires a little more than a normal vehicle (although becoming standard on chrysler). I would recommend picking up
this, this piece does door locks, Trunk release, horn honk, and arm/disarm of factory alarm.