avital 4400 alarm remote start

My friend installed the alarm on my 2004 chevy Tahoe and when i remote start the truck the headlights blink until i turn off remote star and when i open the dooers the alarm doesn't trigger.can some one tell me how to fix this problem.doors lock and remote says locked and armed but the alarm will not trigger.i don't think he knows whats wrong with it. he is an unstaller. but he needs some help.

-------------
mould9

Wire/Function	Colour	Location/Description	Polarity
PASSIVE ANTI-THEFT	YES	PASSLOCK 2	SEE NOTES
12 VOLTS	Red	Ignition switch harness	+
IGNITION	Pink	Ignition switch harness	+
IGNITION 2	White	Ignition switch harness	+
These wire are smaller the other wires from the ignition switch. Test carefully.
ACCESSORY	Orange	Ignition switch harness	+
STARTER	Yellow	Ignition switch harness	+
These wire are smaller the other wires from the ignition switch. Test carefully.
KEY SENSE	Lt.green	At steering column	-
TACH SIGNAL	SEE NOTES
There is a coil for each cylinder, each with a 4-pin plug. Each plug contains a BLACK, BROWN & PINK, as well as a 4th wire which changes color on each coil. This 4th wire can be used as your tach reference, set your remote starter for a 1 cylinder signal.
FUEL INJECTOR	Opposite of Pink wire	At any injector on engine	AC
LOCK	SEE NOTES
The doorlocks are Class 2 Data on this vehicle and cannot be interfaced directly. Interface modules for both doorlocks and security are available for this vehicle. Contact your supplier for more information.
UNLOCK	SEE NOTES
The doorlocks are Class 2 Data on this vehicle and cannot be interfaced directly. Interface modules for both doorlocks and security are available for this vehicle. Contact your supplier for more information.
DOORPIN	Gray/black	At courtesy light under dash	+
FACTORY ARM	SEE NOTES
The doorlocks are Class 2 Data on this vehicle and cannot be interfaced directly. Interface modules for both doorlocks and security are available for this vehicle. Contact your supplier for more information.
FACTORY DISARM	SEE NOTES
The doorlocks are Class 2 Data on this vehicle and cannot be interfaced directly. Interface modules for both doorlocks and security are available for this vehicle. Contact your supplier for more information.
BRAKESWITCH	White	At switch above brake pedal	+
PARKLIGHTS	Gray/black	At light switch harness	-
HAND BRAKE	Lt.blue	At switch on handbrake lever	-
HORN	Black	At steering column	-
VSS WIRE	GREEN/ black	At PCM left front of engine compt.	AC
DATABUS INTERFACE	Pin-2(top row from left)	Diagnostic plug below dash	DATA
PASSLOCK DATA	Yellow	In 3 wire harness from ignition switch	DATA
PASSLOCK GROUND	Black or ORANGE / black	In 3 wire harness from ignition switch	-

Vehicle Notes

PLEASE NOTE: This vehicle is equipped with GM's PASSLOCK 2 passive anti-theft system. Please refer to the appropriate diagram before any remote start installation

What bypass did you use? Check your connection on the parking lights, you MUST have the wrong wire. If you used the correct bypass, the locks and door trigger should be done THRU it. The door pins are also found IN the doors, on both sides.

-------------

I have had many problems out of this alarm right now when i driveing the alarm keeps paging the remote about every 15 minutes and when i unlock the door the dome lights do not light up my installer told me to turn the factory dome light setting off and i did now the dome lights will light up when i disarm the system but will not when i activate the system. can any one tell me whats going on .why does the alarm keep paging its self. and if i leave the dome light switch in the on position when i remote start the truck the alarm goes off. with the dome light switch off when i remote start the truck the alarm doesn't sound. 2004 chevy Tahoe  Help!!

-------------
mould9

TAke it back too the guy who installed it!!!! LEt him fix his mistake

-------------
Suburban boy

Take it back to the guy who put it in.. sounds like he's useing a dome light supervision for your entire alarm trigger.. the alarm keeps paging itself probably because it is seeing an trigger somewhere or not seeing one somewhere.. either way it sounds like you got a bad install... let them deal with it!

-------------
Tire Proz Stillwater Mn
High End Restyling and Comlete Repair

i have a 2004 chevy  tahoe i had the avital 4400 installed everthing is working fine now accept when i am driving the alarm keeps paging the remote .anyone ever had that problem.i need help i had my installer come back 4 times to get the alarm streight. he can not figure out why i getting the pages while driving. it beep 5 times 3 beeps each time

-------------
mould9

i am not familiar with the avital part numbers but i am familiar with the DEI product.

i would say that you may have the "armed while driving" programmed on or the "vrs" security. which is triggered when the door is opened.

on the other hand the system may not be seeing ignition and could be triggering the remote to page the owner because the shock sensor is seeing movement.

if this is a remote starter and alarm system what kind of "security bypass" module did he use? there is a specific module for that truck that will do the door trigger-domelight supervision-locks-security-passlock-and horn honk.

if this module was not used i suggest it. it works nicely and programmes very easy. it is called a 457g and directed electronics sells it. well worth the money.

i hope i could be of some asistance.

-------------
canada's cold eh.

check ur ignition wire on the alarm...

He used 457gw i believe .the system is unarmed and it only happens when i am driveing.this alarm has r emote start. it happens when i remote start or use the key

-------------
mould9

what does the screnn on the pager say when it beeps or does it just beep

Its just beeps

-------------
mould9