Print Page | Close Window

Keyless Entry 93 Ford Explorer

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=8577
Printed Date: August 07, 2025 at 6:46 AM


Topic: Keyless Entry 93 Ford Explorer

Posted By: 1Hawkeye
Subject: Keyless Entry 93 Ford Explorer
Date Posted: January 25, 2003 at 4:27 PM

I need help locating the programming connector for my keyless entry.  I have the instructions from Ford, 2 new remotes, but I want to make sure I jump the correct pins.   I did locate a loose cable in the rear quarter panel when the connection is supposed to be.  I talked to an alarm installer and he was 'kinda sure' it was the connector.  Any help would be greatly appreciated.




Replies:

Posted By: Scott35
Date Posted: January 25, 2003 at 5:38 PM
I always take a paper clip and jump the pins, the key has to be in the run position. If it is the right pins the locks will cycle through. Then push a button on one then another remote.

-------------
Tacomacrew



Posted By: 1Hawkeye
Date Posted: January 25, 2003 at 7:14 PM

and if its not the right connector?  Boom??? bye bye computer???  the guy at the install place said it might be the connector or it could be my air bags.  Since I don't have air bags.  I'm hoping its the right one.  Thanks




Posted By: Scott35
Date Posted: January 25, 2003 at 8:37 PM
The connector is in the drivers side rear panel, pull your tool cover off and look towards the front of it, should be a plug not hooked to anything.

-------------
Tacomacrew



Posted By: 1Hawkeye
Date Posted: February 02, 2003 at 8:35 PM

Thanks Scott, it worked great, saved me lots of money!!!!


Print Page | Close Window