2000 Ford Contour, alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=85969
Printed Date: June 15, 2024 at 7:20 PM

Topic: 2000 Ford Contour, alarm

Posted By: hugosalinas
Subject: 2000 Ford Contour, alarm
Date Posted: November 21, 2006 at 9:06 AM

Im begginer, yesterday i can´t connect my first alarma Xpress.

1.-What means pager set, and where conect this wire.

2.-i need Choose the 4 wires of my car to conect just one 1 wire to roll up, in the alarm.(Window roll up).

car ford contour 2000, 4 doors,

Replies:

Posted By: topper
Date Posted: November 21, 2006 at 11:57 PM

take your car and alarm to your local alarm shop and pay $100-$150 to have them install your alarm. This will be much cheaper then then damage you will inflict on you vehicle.

Posted By: mjwood0
Date Posted: November 22, 2006 at 8:07 AM

I have a Contour as well. They aren't too bad from what I've seen, but they aren't without their quirks. Plus there is very little to solder in if you are new to this (as with most cars).

If you can't figure out the wiring you may be better off going to an install shop. You would really hate to fry anything under the dash. Very expensive to replace harnesses when they burn (not to mention if the car burns).

Posted By: hugosalinas
Date Posted: November 22, 2006 at 9:40 AM

partners just i want to know , what means the wire NEGATIVE PULSED OUTPUT FOR PAGER CALL.

WHERE CONECT THIS WIRE OR DOSN´T CONECT THIS WIRE.

ALARM XPRESS. MODEL DX360.

FORD CONTOUR 2000 posted_image

Posted By: hugosalinas
Date Posted: November 23, 2006 at 9:06 AM

Today Im going to install my alarm Xpres, can conect both wires, alarm´s siren and vehicle´s horn,

Contour 2000 .

Print Page | Close Window