06 Scion xB and Hornet 727T

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=86002
Printed Date: May 11, 2025 at 5:53 PM

Topic: 06 Scion xB and Hornet 727T

Posted By: turbovr6
Subject: 06 Scion xB and Hornet 727T
Date Posted: November 21, 2006 at 9:18 PM

Hello Everyone,

Tomorrow I plan on installing the 727T in an 06' xB. I chose this alarm because I like the use of the OEM keyless remotes.

This appears to be a simple install however I am a bit confused about the door lock/unlock sensing wires. There are 2 wires I need to connect based on what wire reacts to lock/unlock on the OEM remote.

I found the diagrams here in the "install bay" and it looks like I need to use the blue/orange for lock , and YELLOW /GREEN for unlock. In the diagram they are not listed as positive or negative, they are "5wi". I have never seen that term before. What exactly does that mean?

Thanks!!!!

Replies:

Posted By: topper
Date Posted: November 21, 2006 at 11:35 PM

connect blue disarm input wire to the YELLOW /GREEN, connect green arm input to the blue/orange, connect the red disarm defeat input wire to yellow/black (-) located Driver kick panel 14 pin plug. any problems call me at 561-315-7053. P.S. you dont need to connect the blue and green wires in the alarms 3-pin molex

Posted By: turbovr6
Date Posted: November 22, 2006 at 9:35 PM

Thanks for that info!!.. Project postponed due to crappy weather today. looks like I'll have a shot on Friday.

thanks again

Posted By: Mike M2
Date Posted: November 23, 2006 at 8:44 AM

FYI, the term "5 wire" means they rest at a solid ground and flip to positive when locks are activated. Follow Toppers instructions and you'll be fine...

-------------
Mike M2
Tech Manager
CS Dealer Services