1998 plymouth grand voyager remote start

Need help with two things on this vehicle

first all the codes that i pull up list the tach wire for a 2.4l engine but this one has a 3.0 chrysler engine and i can't find the tach wire to hook up to

and secondly it doesn't have a keyless entry with this vehicle but it does have power locks and i can't find the lock and unlock wires either

any help with my situation would be appreciated

-------------
remember keep it simple

|       POWER LOCK|WHITE/ green         |*2 |left plug at bottom of fuse |
|     POWER UNLOCK|same wire           |*2 |box under cover (1 of 3)    |
|       TACHOMETER|gray or gray/red    |   |ignition coil            

*2 --------- Use relays and set up for negative trigger.  Place a 4020 ohm resistor inline on the lock output, and a 665 ohm resistor inline on the unlock output.  If you do not have a factory security system use a 1500 ohm for lock and a 250 ohm for unlock.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

the tach should be gray/red and the ignition coil should be located in the middle behind the engine close to the firewall...pretty sure anyways...

the lock and unlock wire is at the bottom of the fuse box it is white with dark green not white with lte green. it is tight to get to but you can do it without pulling loose the fuse box, just cut that tough tape and usually the lock wire is first one up, good luck tach is in an easy spot at top of engine to the back.

-------------
zargon ruler of estranorth

Also.. Tach wire can be found at the Powertrain contol module.  Gray/Red.

Powertrain control module is found on the drivers fenderwell.

-------------
Hak

Siemens Autostart