Jeep Grand Cherokee, remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=86433
Printed Date: May 15, 2024 at 8:30 AM
Topic: Jeep Grand Cherokee, remote start
Posted By: rumy
Subject: Jeep Grand Cherokee, remote start
Date Posted: November 29, 2006 at 11:33 PM
Hi guys,
First of all i must say this site has been really helpfull, I have a huatai 2 way car alarm and remote starter system, i have done most of the wire, the only thing I need help with is the engine on signal wire.
My remote starter is not like any other starter that uses a tach wire, the wire looks for + 12 v from a ground. So basically when the engine is off it wants it to be -ve and when its on it wants it to be +ve, it asks me to connect it to a oil pressure light,
can any one help me locate the wire.
thanks a tonn in advance.
Replies:
Posted By: KarTuneMan
Date Posted: November 30, 2006 at 3:41 AM
What did you put in it?
-------------
Posted By: rumy
Date Posted: November 30, 2006 at 4:07 AM
im sorry? I dont quite understand?
Posted By: Hymer
Date Posted: November 30, 2006 at 10:00 AM
when the engin is running the oil pressure doesnt send 12v first of all... you need a circuit on the motor that only produces 12v while the ening is running... I have heard of this before, but good luck in a jeep..I suppose you could do it off the alternator or voltage regulator... why companies have to make products that really make NO sense, as far as the common installation practices is beyond me....
-------------
Tire Proz Stillwater Mn
High End Restyling and Comlete Repair
Posted By: start25
Date Posted: November 30, 2006 at 10:10 AM
I installed this one before, and I just hooked it up to the tech wire.... Works fine...
|