2002 honda accord coupe wiring
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=86524
Printed Date: May 01, 2025 at 6:49 AM
Topic: 2002 honda accord coupe wiring
Posted By: almeida79
Subject: 2002 honda accord coupe wiring
Date Posted: December 02, 2006 at 8:11 AM
Hi I need a wiring diagram for a 2002 honda accord coupe for a remote start . Any help will gladly be appreciated . Thank's Jason
------------- Jay
Replies:
Posted By: Mike M2
Date Posted: December 02, 2006 at 8:53 AM
12volts | white | + | ignition harness | Starter | BLACK/ white | + | ignition harness | Notes: If doing starter kill, must interrupt the wire between the keyswitch and the fusebox, not between the fusebox and the starter, to keep the check engine light from coming on. | Second Starter | N/A | | | Ignition | BLACK / YELLOW | + | ignition harness | Second Ignition | N/A | | | Third Ignition | N/A | | | Accessory | yellow | + | ignition harness | Second Accessory | WHITE/ black | + | ignition harness | Keysense | | | | Power Lock | BLACK/ blue | - | passenger side fuse box | Notes: in a green 20 pin connector.
Use BLACK/ white for lock and GREEN/ red for unlock on LX models without factory security. These wires are located in a two pin gray connector by the front of the drivers side fuse box. | Power Unlock | orange | - | passenger side fuse box | Notes: in a green 20 pin connector.
Use BLACK/ white for lock and GREEN/ red for unlock on LX models without factory security. These wires are located in a two pin gray connector by the front of the drivers side fuse box. | Lock Motor | WHITE/ red | | driver side fuse box | Unlock Motor | | | driver side fuse box | Notes: yellow on the EX and lt. GREEN/ red on the LX | Parking Lights+ | RED / black | | driver side fuse box | Parking Lights- | RED / yellow | | steering column | Notes: Only available on the EX model. | Hazards | | | | Turn Signal(L) | | | | Turn Signal(R) | | | | Reverse Light | GREEN/ black | + | driver side fuse box | Door Trigger | BLACK/ white | - | passenger side fuse box | Notes: In a green 4 pin connector. | Dome Supervision | use door trigger | | | Trunk/Hatch Pin | orange | - | drivers kick panel | Notes: Above the hood release in a gray 18 pin connector. On the DX & LX models, also found in a 2 pin connector behind the drivers fuse box. | Hood Pin | yellow/red or yellow | - | hood pin switch or | Notes: On the EX models it is in a green plug next to the passenger side fuse box. On the LX models it is at the keyless/security unit, if equipped, which is attached to the driver side underdash panel. | Trunk/Hatch Release | WHITE/ red | + | drivers kick panel | Power Sliding Door | | | | Factory Alarm Arm | | | | Notes: Arms and disarms with the door locks on the EX models. The LX models arm only with the factory transmitter. | Factory Alarm Disarm | | | | Notes: Arms and disarms with the door locks on the EX models. The LX models arm only with the factory transmitter. | Disarm No Unlock | blue | - | | Notes: On the EX the wire is located at the drivers power window switch, on the LX the wire is at the keyless/security unit which is attached to the drivers underdash panel. | Tachometer | blue | | tach test connector | Notes: The tach test connector is located behind the battery on the 4 cylinder, and on a bracket attached to the drivers side strut tower on the 6 cylinder motor. The tach test connector is a white 2 pin connector, and may be covered by a black rubber boot. | Wait to start | | | | Brake Wire | WHITE/ black | + | brake pedal switch | Parking Brake | | | | Horn Trigger | lt. GREEN/ blue | - | steering column | Memory Seat 1 | | | | Memory Seat 2 | | | | Memory Seat 3 | | | |
Interface Module: | Category: Immobilizer Bypass | Required: Yes | Type: Transponder | Part #: 1100F | Alternate Part1 #: 1100X | Alternate Part2 #: 556HW | Alternate Part3 #: 556UW | Alternate Part4 #: DesignTech 20402 | Alternate Part5 #: DesignTech 29402 | Notes: When using the 1100F or 1100X, a software change to 1100HA is needed. | Interface Module: | Category: Door Lock Interface | Required: No | Type: Data Bus | Part #: IM-Honda-2 |
------------- Mike M2
Tech Manager
CS Dealer Services
|