06 Durango disarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=86576
Printed Date: April 28, 2024 at 3:30 PM
Topic: 06 Durango disarm
Posted By: azn_fcuk
Subject: 06 Durango disarm
Date Posted: December 03, 2006 at 2:29 PM
i know it disarms from remote, will it have any problems when it remote starts? will the starter set off the factory alarm?
Replies:
Posted By: Velocity Motors
Date Posted: December 03, 2006 at 2:40 PM
As long as you have the Sentry bypass done properly, the OEM alarm will disarm through the ignition power up & Sentry bypass.
------------- Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: extreme1
Date Posted: December 03, 2006 at 8:22 PM
on the 05/06 Jeff I've found you need keysense hooked up as well. I just split my (-) accesory wire into two with diodes and run the second one to the keysense wire.
------------- Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
Posted By: azn_fcuk
Date Posted: December 03, 2006 at 10:13 PM
does it have to be access to keysence or can i use my GWR wire?
Posted By: azn_fcuk
Date Posted: December 05, 2006 at 12:38 PM
I just did the install, everything works fine but when locked and armed the factorty alarm goes off. Im guess i need to hook up my ground while running wire to the key sense wire. Is this correct?
Posted By: azn_fcuk
Date Posted: December 05, 2006 at 12:41 PM
Oh and another thing i found out the hard way, YOU MUST HOOK UP THE PURPLE 3rd ACCESSORY WIRE lol, set off my ABS light untill i figuared it out.
Posted By: Mr_Fusion
Date Posted: December 05, 2006 at 5:51 PM
I did an early 00s model Grand Cherokee with JUST remote start...(customer request) and I did not initially hook up the Factory Disarm Wire...and yes, it will disarm the factory alarm during remote start but it may set the alarm off for a couple of seconds before it really disables the alarm system.
Posted By: kustomkingsiny
Date Posted: December 05, 2006 at 7:44 PM
yes u must hook up the keysense wire which i think i purple white.....cant remember i do these on a daily basis and also the accessory and the ignition wires must all be hooked up in order for night lights on the dash to light up
------------- KustomKing Of Staten Island
Posted By: azn_fcuk
Date Posted: December 06, 2006 at 2:59 AM
thatnks, the only problem i had was the key sense, when i had tested the vehicle it was with the doors unlocked and disarmed, so it seemed to of worked fine. Oh well 5 mintue fix at least :) Thanks for the help everyone
|