2005 Jeep Liberty, remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=86694
Printed Date: May 15, 2025 at 11:40 AM
Topic: 2005 Jeep Liberty, remote start
Posted By: mnviking28
Subject: 2005 Jeep Liberty, remote start
Date Posted: December 05, 2006 at 10:05 PM
I am looking for a wiring diagram to install a remote start in a 2005 Jeep Liberty. It has the factory remote in key and I have already gotten a bypass XK03 from bypasskits.com. I have found a few vague diagrams, but nothing that is real helpful.
------------- MNViking28
Replies:
Posted By: KarTuneMan
Date Posted: December 05, 2006 at 11:49 PM
Wire/Function | Colour | Location/Description | Polarity | PASSIVE ANTI-THEFT | YES | TRANSPONDER | SEE NOTES | 12 VOLTS | Red | Ignition switch harness | + | IGNITION | Pink/green | Ignition switch harness | + | ACCESSORY | Pink / YELLOW | Ignition switch harness | + | | | There are 2 Pink / YELLOWs, one for the radio and one for heater, test carefully. |
| STARTER | Lt.blue/red | Ignition switch harness | + | KEY SENSE | Violet/tan | Ignition harness | - | TACH SIGNAL | SEE NOTES | | | | | There is an uncommon wire at each coil which can be used for tach. |
| FUEL INJECTOR | Opposite from ORANGE / dk.green | At any injector on engine | AC | LOCK | Tan/blue (1500-ohms) | In large harness to left of brake pedal | - | | | This is a 1-wire system with resistors. The keyless entry is built in to the ignition key and works even while the vehicle is running. Unless you are installing after-market security, no connection to the doorlock wire is required. |
| UNLOCK | Tan/blue (470-ohms) | In large harness to left of brake pedal | - | | | This is a 1-wire system with resistors. The keyless entry is built in to the ignition key and works even while the vehicle is running. Unless you are installing after-market security, no connection to the doorlock wire is required. |
|
-------------
Posted By: KarTuneMan
Date Posted: December 05, 2006 at 11:49 PM
DOORPIN | SEE NOTES | | | | | Violet (left front), Violet/white (right front), Violet/gray (left rear) & Violet / YELLOW (right rear) all 4 wires are (-) and found in the large white plug above the driver's kickpanel. |
| TRUNK PIN | Tan/black or Violet/orange | In large White plug above driver's kickpanel | - | TRUNK RELEASE | Blue/green or lt.GREEN / WHITE | In large White plug above driver's kickpanel | + | FACTORY ARM | SEE NOTES | | | | | To arm the alarm, pulse the TAN driver's doorpin at the same time as the lock wire. |
| FACTORY DISARM | Disarms with unlock | | | BRAKESWITCH | WHITE/ tan | At switch above brake pedal | + | PARKLIGHTS | Pink/red (900-ohms) | At steering column | - | HAND BRAKE | GREEN / WHITE | At switch on handbrake lever | - | HORN | GREEN/ violet | At steering column | - | VSS WIRE | GREEN/ YELLOW | Behind fusebox (under driver side dash) | AC | DATABUS INTERFACE | Pin-2(top row from left) | Diagnostic plug below dash | DATA |
Available Notes | PLEASE NOTE: This vehicle is equipped with TRANSPONDER chips in the ignition keys. This system must be bypassed for Remote Starter installation. A keyless bypass module may be available, contact your distributor to find out. If one of these modules is not available to you, see the appropriate security diagram for bypass instructions.
|
-------------
|