2000 Bonneville, 555G problem
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=86760
Printed Date: July 07, 2025 at 8:38 AM
Topic: 2000 Bonneville, 555G problem
Posted By: slayder
Subject: 2000 Bonneville, 555G problem
Date Posted: December 06, 2006 at 10:04 PM
Hi
I installed a BOA 165B with 555GW into a 2000 Bonneville (Passkey III). I tried starting it before the 555G and it worked fine with the key in the ON position. Another weird thing it's doing, it keeps on flashing the lights even after the vehicle is on.
So the problem is, I can't find the Immobilizer ignition wire (White or Pink) the one I'm supposed to cut and connect the Pink/Black to the key side and the Pink to the ECM side. Also in the install it says to get to the Purple data wire at the ignition, again it's not there and I had to go to the OBD connector Pin2. Jumper is set to data but when I press the button on R/S the 555G LED flashes even after the car is started??? I've found 2-white and 1-pink wire at the ignition switch and tried them all but no luck still flashing. Any help???
Replies:
Posted By: extreme1
Date Posted: December 07, 2006 at 8:56 AM
isn't a 2000 bonneville VATS, 555g is for passkey3
does the key have a resistor pellet in it?
if so you have the wrong bypass
-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
Posted By: slayder
Date Posted: December 07, 2006 at 10:39 AM
No, the key got a PK3 on it. I'm having trouble finding them.
Posted By: slayder
Date Posted: December 07, 2006 at 12:21 PM
Is it normal that during programing of the 555G that it flashes every sec? Or should the LED stay lit until the car is started/programmed?
|